Total 17 results found for the keyword of "eos layer 2 subinterfaces"
... VID). A frame must arrive on the parent interface with the configured tag to be processed by the subinterface.
Routed Parent Port
eos typically creates layer 2 subinterfaces on a routed port,an ...
layer 3 Configuration
This chapter covers the following layer 3 sections:
IPv4
IPv6
Ingress and Egress Per-Port for IPv4 and IPv6 Counters
ACLs and Route Maps
VRRP and VARP
DirectFlow
Decap ...
layer 2 Protocol Forwarding
eos supports layer2 (L2) Protocol Forwarding on Ethernet interfaces in addition to
Type-5 PW. Also, eos allows selective forwarding of certain L2 Protocol packets, such ...
layer 2 Configuration
This chapter contains the following sections:
Spanning Tree Protocol
Link layer Discovery Protocol
Virtual LANs (VLANs)
DCBX and Flow Control
IP Address Locking
layer 2 ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... the advertisement of all labels in the LIB. eos supports this feature
for the following Pseudowire types:
Prefix FECs - Sends notification when labels for all local and remote IP
prefixes have advertised. ...
...
eos adds a new parameter in the output, evpn prefix detail to display the
ATTR_SET, code 128 attributes.
switch#show bgp evpn
BGP routing table information for VRF default
Router identifier 10.11.0.1, ...
... list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified RIB domains, overriding the default behavior. Further, ...
Ingress and Egress Per-Port for IPv4 and IPv6 Counters
This feature supports per-interface ingress and egress packet and byte counters for IPv4
and IPv6.
This section describes Ingress and Egress ...
... resource usage on each forwarding
ASIC. eos installs ACLs only on the hardware components corresponding to the member interfaces
of the SVIs with an applied ACL, and saves hardware resources and scales ...
... Configuration
Procedures
VLAN Configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... Type Ports
---- ----------- ---- -----
Total Mac Addresses for this criterion: 0
Beginning with eos Release 4.26.0F,
PortSec-Protect enforces a limit on the number of ...
... It is highly recommended that both MLAG peer switches are
identical platforms and run identical eos images. Running different images/platform may
result in a failure to form an association with the MLAG ...
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
Quality of Service
This chapter describes the eos Quality of Service (QoS) implementation, including configuration instructions and command descriptions. Topics covered by this chapter include ...
... eXtended Packet Numbering (XPN) cipher suites.
MACsec Limitations
The following are the limitations of MACsec:
eos supports MACsec only on point-to-point links unless static SAK is ...