Total 34 results found for the keyword of "eos section 7 2 configuration files"
Standard Upgrades and Downgrades
Standard software upgrades
and downgrades on Arista switches are accomplished by installing a different
eos image and reloading the switch. On switches with redundant ...
...
The switch controls access to eos commands by authenticating user identity and verifying user authorization. Authentication, Authorization, and Accounting (AAA) activities are conducted through three ...
... successor to Secure Sockets Layer (SSL), is a security protocol used to communicate between client and server. It establishes an encrypted communication channel to secure data.
By default, eos uses a ...
...
MACsec Licensing
MACsec encryption is a eos licensed feature. A valid MACsec license must be configured on a switch. MACsec licenses are tied to a switch serial number and the licensee. ...
Setting the PTP Transport Type
To set the PTP transport type, use the ptp
transport command.
This command configures the PTP transport type for the interface to IPv4.
switch(config-if-Et5)# ptp transport ...
Precision Time Protocol (PTP) Commands
PTP Commands
ptp announce interval
ptp announce timeout
ptp delay-mechanism
ptp delay-req interval
ptp domain
ptp enable
ptp forward-v1
ptp hold-ptp-time ...
... command replaces the EOS CLI prompt with an SQLite
prompt.switch# event-monitor interact
sqlite>
This command exits SQLite and returns to the EOS CLI
prompt.sqlite> .quit
switch#
event-monitor ...
...
Restoring the Factory Default eos Image and Startup configuration
USB Support for ZeroTouch Provisioning
Restoring the configuration and Image from a USB Flash Drive
The first three procedures require ...
... CLI.
This chapter includes these sections:
Accessing the eos CLI
Processing Commands
Kernel-based Virtual Machine Commands and configuration
Switch Platforms
Command Modes
Managing Switch
configuration ...
Booting the Switch
This chapter describes the
switch boot process, describes configuration options, and lists the components
it requires, including the boot loader, the boot loader shell, and other
configuration ...
... be accessed only through the console port, and the command set is
limited. Any configuration changes made on the standby supervisor will
be lost when the supervisor reboots.
Note: When upgrading the eos ...
... system
Aboot 1.9.0-52504.eos2.0
Press Control-C now to enter Aboot shell
To continue the reload process, do nothing. Typing Ctrl-C opens the
Aboot shell; see Aboot Commands
for Aboot editing ...
... Operation
When the switch is powered on or rebooted, Aboot reads its configuration from
boot-config on the internal flash and attempts
to boot an eos software image (with the extension
.swi) automatically ...
... 1
stop bit. If you do not know the current settings, restore the factory-default
settings as described in Restoring the Factory Default eos Image and Startup configuration.
The no boot console and default ...