CloudVision Physical Appliance Setup

You may need the following items to perform the procedures in this section:

  • Key to the system key-lock.
  • #1 and #2 Phillips screwdriver.
  • Wrist grounding strap connected to ground.
  • Rack mount kit instructions located in the shipping box.

Before Working Inside your System

Follow these safety guidelines: Safety Information.

  1. Turn off the system, including all attached peripherals.
  2. Disconnect the system from the electrical outlet and disconnect the peripherals.
  3. Remove the system cover.

Front Bezel

Locate the MAC Addresses for the CloudVision Appliance

Back Panel Ethernet Connections

DNS Entries

Front Bezel

Complete the following tasks to remove the front bezel.

Figure: Front Bezel

  1. Unlock the key-lock at the left end of the bezel.
  2. Lift the release latch next to the keylock.
  3. Rotate the left end of the bezel away from the front panel.
  4. Unhook the right end of the bezel and pull the bezel away from the system.

Locate the MAC Addresses for the CloudVision Appliance

The information tag is a slide-out label which contains system information such as Service Tag, NIC, MAC address for your reference. Record the MAC addresses in the CloudVision Worksheet.

 

Figure: Locating MAC Address of your System

 
1 - Information tag (front view) 2 - Information tag (back view)
3 - OpenManage Mobile (OMM) label 4 - iDRAC MAC address and iDRAC secure password label
5 - Service Tag  

Back Panel Ethernet Connections

On the back panel of the CloudVision appliance, locate the Ethernet Integrated 10/100/1000 Mbps NIC connectors.

Figure: Back Panel
Figure: Subnet 1 and Subnet 2 Configuration

 

iDRAC is an Intelligent Platform Management Interface (IPMI) that provides a GUI-based out-of-band interface for monitoring the hardware appliance.

Record the IP address and Hostname information in CloudVision Worksheet.

Note: iDRAC may also be referred to as Lifecycle Controller.

DNS Entries

In order to manage your CloudVision cluster, it is often easier to connect to them by hostname as opposed to IP address. Fully qualified domain names (FQDNs) should be allocated to:

  • Each of the CloudVision Appliance host machines.
  • Each of the CloudVision Appliance iDRAC interfaces.
  • Each of the CloudVision Portal (CVP) nodes.
  • Each of the CloudVision Server (CVX) nodes.

Contact your DNS zone administrator for assistance.