Total 8 results found for the keyword of "wap c460 install the access point"
installing the access point
This section contains the procedure to install the access point (AP).
Zero-Configuration of the access point
the AP supports zero-configuration under the following ...
AP-Server Mutual Authentication
the AP-server communication begins with a mutual authentication step where the AP and server authenticate each other using a shared secret. If this authentication ...
Connecting the access point to the Network
To connect the AP to the network, perform the following steps:
Be sure to install the AP on a network with a DHCP-enabled server.
Set up a DNS entry ...
Powering the access point On
Power the access point (AP) on by plugging one end of the Ethernet cable into the Power over Ethernet++ (PoE++) switch or injector and the other end into the Ethernet/PoE++ ...
access point Troubleshooting
the table below lists some of the access point (AP) troubleshooting guidelines.
Problem
Solution
the AP did not receive a valid IP address via ...
access point Overview
C-460 is a multi-radio 802.11be access point. Refer to the C-460 datasheet for more information.
Note: This equipment is suitable for use in environment air spaces ...
Package Content
the access point (AP) package must contain the components shown in the following figure.
Figure 1. Package Components
1
C-460 access point
2
15/16" (24 ...
About This Guide
This installation guide explains deploying the C-460 access point (AP).
Important:Read the EULA before installing the access point (AP). You can download and read the EULA ...