- Written by Kewei Shi
- Posted on August 24, 2020
- Updated on June 12, 2024
- 7927 Views
This document describes the configuration and behavior of physical interfaces on the 7368 series switches and
- Written by Tarun Jaswanth LNU
- Posted on August 24, 2020
- Updated on October 17, 2024
- 25436 Views
802.1X is an IEEE standard protocol that prevents unauthorized devices from gaining access to the network.
- Written by Michael (Mike) Fink
- Posted on December 22, 2017
- Updated on September 25, 2023
- 13903 Views
Filtered Mirroring allows certain packets to be selected for mirroring, rather than all packets ingressing or egressing a particular port.
- Written by Francesco Belletti
- Posted on August 20, 2020
- Updated on August 20, 2020
- 7513 Views
This feature adds support for “Enhanced Route Refresh” capability (RFC7313). An enhanced route refresh is,
- Written by Nandan Saha
- Posted on August 24, 2020
- Updated on May 22, 2024
- 11180 Views
The BGP-LS extension allows IGPs (OSPF/IS-IS) link state database information to be injected into BGP. This is typically used in deployments where some external component, (like a controller or Path Computation Engine) can do centralized path computations by learning the entire IGP topology through BGP-LS. The controller can then communicate the computed paths based on the BGP-LS updates to the head end device in the network. The mechanism used by the controller to communicate the computed TE paths is outside the scope of this document. Using BGP-LS instead of an IGP peering with the controller to distribute IGP link state information has the following advantages.
- Written by Srinivasan Koona Lokabiraman
- Posted on August 25, 2020
- Updated on August 25, 2020
- 7851 Views
The BGP graceful restart mechanism has a limitation that the graceful restart time cannot exceed 4095 seconds as per
- Written by Kaushik Kumar Ram
- Posted on August 21, 2020
- Updated on October 17, 2024
- 8964 Views
Generic UDP Encapsulation (GUE) is a general method for encapsulating packets of arbitrary IP protocols within a UDP tunnel. GUE provides an extensible header format with optional data. In this release, decap capability of GUE packets of variant 1 header format has been added. This variant allows direct encapsulation using the UDP header without the GUE header. The inner payload could be one of IPv4, IPv6, or MPLS.
- Written by Kevin Amiraux
- Posted on September 30, 2015
- Updated on August 16, 2024
- 10927 Views
Arista switches provide several mirroring features. Filtered mirroring to CPU adds a special destination to the mirroring features that allows the mirrored traffic to be sent to the switch supervisor. The traffic can then be monitored and analyzed locally without the need of a remote port analyzer. Use case of this feature is for debugging and troubleshooting purposes.
- Written by Navdeep Bhatia
- Posted on August 24, 2020
- Updated on August 25, 2020
- 6706 Views
Route Cache is a feature where users can configure Static EVPN VXLAN routes beyond the hardware capacity. The
- Written by Haotian Zhang
- Posted on June 4, 2020
- Updated on May 31, 2024
- 8399 Views
This article describes the support for Filtered Mirroring using security ACL. The user can selectively mirror packets based on the statement in the configured IPv4, IPv6 or MAC ACL.
- Written by Rajiv Patil
- Posted on September 16, 2020
- Updated on August 30, 2024
- 14730 Views
Dynamic NAT is a feature which dynamically allocates an IP address to an incoming or outgoing flow. This address will replace source or destination IP for all packets of the flow.
- Written by Legena P K
- Posted on August 21, 2020
- Updated on May 31, 2024
- 6949 Views
IPv6 Unicast Reverse Path Forwarding (uRPF) can help limit malicious IPv6 traffic on a network. uRPF works by
- Written by Charlotte Fedderly
- Posted on August 25, 2020
- Updated on February 21, 2024
- 9181 Views
This feature adds support for a selected set of configured interfaces to collect egress flow samples. Egress sFlow can be configured on ethernet and port-channel interfaces.