Total 8 results found for the keyword of "wap c130 power the access point on"
power on the C-130
the C-130 device can be powered on by plugging one end of the Ethernet cable into the PoE+ (802.3at) switch or injector and the other end into the Ethernet/PoE+ port on the C-130. ...
Connect C-130 to the Network
the device can be connected to the network by connecting through a LAN cable or a POE+ injector. If you are using a PoE+ injector, make sure the data connection is plugged ...
Mount the C-130
the steps to mount the C-130 involve:
Mounting Instructions using the Standard Package Contents
Mounting Instructions using the Silhouette/Interlude Bracket Mount.
Mounting ...
Install the C-130
This chapter contains the step wise procedure to install the C-130 device.
Zero-Configuration of C-130 as access point
Zero-configuration is supported under the following ...
Top Side Ports on C-130
Describes the supported AC power supplies and lists the power cables you can use to connect the supply to a power source.
Port
Description
Connector ...
Rear Panel of C-130
the rear panel of the C-130 provides an PoE+ Ethernet port that enables you to connect the device to a wired LAN through a switch or a hub and power the device by using the 802.3af/802.3at ...
Front Panel of C-130
the front panel of the C-130 has 4 functional LEDs that indicate the working of the device.
power LED: the following table describes the power LED states.
Table 1. power ...
C-130 Overview
C-130 is a 4x4 802.11a/b/g/n/ac access point with three radios.
This chapter provides an overview of the C-130 and describes:
Front Panel of C-130
Rear Panel Ports on C-130 ...