Total 12 results found for the keyword of "eos 11 2 port channel conceptual overview"
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... available for other eos applications. With hardware acceleration, all sFlow processing is done in hardware using specialized chips, called accelerators. These accelerators process sampled packets and ...
... can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version. This chapter ...
Routing Information Protocol (RIP) This chapter contains the following sections. RIP conceptual overview Running RIP on the Switch Configuring RIP on Multiple VRFs RIP Commands RIP conceptual ...
... for OSPFv2 adjacencies with DR Other neighbors. OSPFv2 Multiple Instances Support eos Release 4.22.1F adds support for multiple OSPFv2 instances to be configured in the default VRF. OSPFv2 Multiple ...
... area and interface levels. Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another ...
... hop resolution semantics of BGP routes with an ordered list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified ...
VRRP and VARP A virtual IP (VIP) address is an IP address that does not directly connect to a specific interface. Inbound packets sent to a Virtual IP address are redirected to a physical network ...
... Configuration Procedures VLAN Configuration Commands VLAN Introduction Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
...  eos is optimized to support QoS configuration on the Fabric interfaces on 7250x and 7300 series switches. Configuring QoS on the Fabric interfaces in addition to front panel ports allows user to have ...
... 32-bit integer used in the candidate path selection algorithm to select the “active” candidate path. The default value for preference is 100. Binding SID (BSID): an optional, SID.Note: In eos, a BSID ...
... MLAG peer switches are identical platforms and run identical eos images. Running different images/platform may result in a failure to form an association with the MLAG peer or see discrepancy in behavior. ...