Total 13 results found for the keyword of "eos 6 3 supervisor redundancy"
... be accessed only through the console port, and the command set is
limited. Any configuration changes made on the standby supervisor will
be lost when the supervisor reboots.
Note: When upgrading the eos ...
...
Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667.
The following enhancements are available by release:
eos Release 4.22.1F adds support ...
... ensure disable-vrf configuration to take effect.
switch(config)# agent SandL3Unicast terminate
SandL3Unicast was terminated
Starting from the eos Release 4.26.0F, /32 prefix length optimization ...
... (eos release
4.25.2F)
Support of 400GBASE-ZR with Open Forward Error Correction (O-FEC) (eos release
4.25.2F)
Override a transceiver slot’s maximum power limit (eos release
4.25.2F)
Platform Compatibility ...
... MLAG peer switches are identical platforms and run identical eos images. Running different images/platform may result in a failure to form an association with the MLAG peer or see discrepancy in behavior. ...
Standard Upgrades and Downgrades
Standard software upgrades
and downgrades on Arista switches are accomplished by installing a different
eos image and reloading the switch. On switches with redundant ...
Environment Control Overview
This section contains the following topics:
Temperature
Fans
Power
Temperature
Arista switches include internal temperature sensors. The number and location ...
... command replaces the EOS CLI prompt with an SQLite
prompt.switch# event-monitor interact
sqlite>
This command exits SQLite and returns to the EOS CLI
prompt.sqlite> .quit
switch#
event-monitor ...
... label, and be mounted to the same mount
point with the same options. This makes it possible to boot the eos again by installing
a new boot-config and eos SWI, then rebooting (which can be done using
Aboot/fullrecover). ...
Booting the Switch
This chapter describes the
switch boot process, describes configuration options, and lists the components
it requires, including the boot loader, the boot loader shell, and other
configuration ...
... have not been saved since
the last boot.
boot-config
The boot-config file is an ASCII file that Aboot uses to configure console
communication settings, locate the eos flash image, and specify
initial ...
... system
Aboot 1.9.0-52504.eos2.0
Press Control-C now to enter Aboot shell
To continue the reload process, do nothing. Typing Ctrl-C opens the
Aboot shell; see Aboot Commands
for Aboot editing ...
... 1
stop bit. If you do not know the current settings, restore the factory-default
settings as described in Restoring the Factory Default eos Image and Startup Configuration.
The no boot console and default ...