Total 28 results found for the keyword of "eos section 23 4 stp commands"
Precision Time Protocol (PTP) commands
PTP commands
ptp announce interval
ptp announce timeout
ptp delay-mechanism
ptp delay-req interval
ptp domain
ptp enable
ptp forward-v1
ptp hold-ptp-time ...
... command replaces the EOS CLI prompt with an SQLite
prompt.switch# event-monitor interact
sqlite>
This command exits SQLite and returns to the EOS CLI
prompt.sqlite> .quit
switch#
event-monitor ...
... 1
stop bit. If you do not know the current settings, restore the factory-default
settings as described in Restoring the Factory Default eos Image and Startup Configuration.
The no boot console and default ...
...
Drop count
Device ID
Egress interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP Aggregation ...
... displays
information about the active flows maintained in the eos.
Command Mode
EXEC
Command Syntax
show flow tracking sampled flow-table [
detail | dst-ip |
dst-port | group |
interface | protocol ...
... available for other eos applications.
With hardware acceleration, all sFlow processing is done in hardware
using specialized chips, called accelerators. These accelerators
process sampled packets and ...
Sample Configurations
EVPN VXLAN IRB Sample Configuration
In the topology below, we are connecting a Layer 2 site with a Layer 3 site using Layer 3
EVPN (type-5 route). Right side leaves are MLAG ...
BGP/MPLS L3 VPN
Border Gateway Protocol/ Multiprotocol Label Switching (BGP/MPLS) L3 Virtual rivate Network (VPN)
allows a Service Provider (SP) or an Enterprise to provide the
service of interconnecting ...
LDP Pseudowire
LDP pseudowire provides support for emulating Ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
EVPN VXLAN Single-Gateway Centralized Routing
In a traditional EVPN VXLAN centralized anycast gateway deployment, multiple L3 VTEPs
serve the role of the centralized anycast gateway. In order for ...
VCS to EVPN Hitless Migration
VCS to EVPN Hitless Migration enables support for migrating from only using VCS as the control plane to only using EVPN as a control plane in a hitless manner with respect ...
IGMP and IGMP Snooping
IGMP Snooping
IGMP Host Proxy
Description
Supported Features
IGMP Protocols
Configuring IGMP
Configuring IGMP Snooping
IGMP Host Proxy
IGMP and IGMP Snooping
commands ...
Audio Video Bridging (AVB)
Arista switches support Audio Video Bridging (AVB) and the associated protocols. This section describes AVB concepts and the implementation of associated protocols.
Topics ...
... for OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos Release 4.22.1F adds support for multiple OSPFv2 instances to
be configured in the default VRF. OSPFv2 Multiple ...
... hop resolution semantics of BGP routes with an ordered list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified ...
... and destination
addresses..
ACLs can also be made dynamic (not persisting in the eos), and the
payload keyword can be used to
turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
... that are configured by a custom agent using the eos SDK or eAPI
and age out (expire) after a specified time period.
For example, if you are using a custom agent that reacts to traffic sent to the CPU ...
Spanning Tree Protocol
Spanning Tree Protocols prevent
bridging loops in Layer 2 Ethernet networks. Arista switches support
Rapid Spanning Tree, Multiple Spanning Tree, and Rapid-Per VLAN Spanning
Tree ...
... Configuration
Procedures
VLAN Configuration
commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
Layer 2 Protocol Forwarding
Layer2 (L2) Protocol Forwarding on Ethernet interfaces is supported, in addition to
Type-5 PW. Also, selective forwarding of certain L2 Protocol packets
(tagged/untagged/all) ...