Total 30 results found for the keyword of "eos section 26 2 ipv6 description"
... snooping is a Layer 2 feature that is configured on LAN switches. The Arista eos switch supports Option-37 insertion that allows relay agents to provide remote-id information in DHCP request packets. DHCP servers ...
Ingress and Egress Per-Port for IPv4 and ipv6 Counters This feature provides support for per-interface ingress and egress packet and byte counters for both IPv4 and ipv6. This section describes Ingress ...
...  Drop count Device ID Egress interface FCS type Reserved TAP Aggregation Extra MPLS Pop (4 to 6 Labels) Available starting with eos Release 4.23.1F extra MPLS pop for TAP Aggregation ...
... displays information about the active flows maintained in the eos. Command Mode EXEC Command Syntax show flow tracking sampled flow-table [ detail | dst-ip | dst-port | group | interface | protocol ...
... available for other eos applications. With hardware acceleration, all sFlow processing is done in hardware using specialized chips, called accelerators. These accelerators process sampled packets and ...
... can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version. This chapter ...
Sample Configurations EVPN VXLAN IRB Sample Configuration In the topology below, we are connecting a Layer 2 site with a Layer 3 site using Layer 3 EVPN (type-5 route). Right side leaves are MLAG ...
...  Starting in Release eos 4.23.1, ingress on inner IP header matching in MPLS packets is also supported on PBR ACLs. In order to enable this, the following must be configured in a user-defined TCAM profile: ...
... it is binding a label. Note: All connected interfaces are advertised as bound. However, eos currently advertised labels for /32 addresses, and FEC filter is configured to install only x.x.x.200/32 prefixes. ...
... is the protocol used to manage the membership of hosts in multicast groups for ipv6. RFC 3810 talks about MLDv2 functionality. MLDv2 is the ipv6 counterpart of IGMPv3. Beginning with eos Release 4.25.0F, ...
... identifier or a single Customer Edge (CE) to the participating multiple Provider Edge (PE). The default mode of operation is All-active. Introduced in the eos 4.26.0F for VxLAN, singe-active is another ...
... for OSPFv2 adjacencies with DR Other neighbors. OSPFv2 Multiple Instances Support eos Release 4.22.1F adds support for multiple OSPFv2 instances to be configured in the default VRF. OSPFv2 Multiple ...
... area and interface levels. Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another ...
...  Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667. The following enhancements are available by release: eos Release 4.22.1F adds support ...
... hop resolution semantics of BGP routes with an ordered list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified ...
...  Maintenance Mode Configuration Maintenance Mode Commands Overview Using maintenance mode, you can perform several maintenance activities such as: eos image upgrade. Initial configuration or ...
... and destination addresses.. ACLs can also be made dynamic (not persisting in the eos), and the payload keyword can be used to turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
VRRP and VARP A virtual IP (VIP) address is an IP address that does not directly connect to a specific interface. Inbound packets sent to a Virtual IP address are redirected to a physical network ...
Decap Groups These sections describe the Decap groups: Decap Groups description Decap Groups Configuration Decap Commands Decap Groups description The decap group is a data structure that ...
Nexthop Groups These sections describe the Nexthop groups: Nexthop Group description Nexthop Group Configuration Support for ipv6 Link-Local Addresses in Nexthop Groups Entries Nexthop Group Commands ...