打印

Wi-Fi Access Point O-435E - Powering on the Access Point 打印

Powering on the Access Point

Plug one end of the Ethernet cable into the PoE++ switch or compatible PoE injector, a Single-port High Power Midspan, 802.3bt compliant, up to 5Gigabit PoE with PD54V in power output, and the other end into the LAN1 (PoE++) on the AP. Be sure to turn on the PoE++ source. Use an active wrench with a 27 mm opening to open the LAN (PoE++) port cap.

The access point (AP) package must contain the components shown in the following figure.
Figure 1. Use Active Wrench
Use an active wrench to open the LAN cap.
Table 1. Labels: Measurements
Label Description
1 The LAN port cap has a width of 27mm.
2 Use an active wrench to open the LAN port cap.
3 Insert LAN cable.

Earthing or Grounding: The AP must be properly grounded using a copper grounding wire (12 ~ 10 AWG) and a tin-plated lug as shown in the following image. The wire and the lug must be tightened at the grounding screw on the AP.

Note: Connect the power cord of the power adapter, if used, to a socket outlet with an grounding connection.

The following two images show the position of the grounding screw on the AP, displayed as 1, and the dimension of the lug that attaches to the grounding screw.

Figure 2. Position of the Grounding Screw on the AP
Figure 3. Lug Nut Dimension
Note: The O-435E APs requires a UL-listed PoE+ power source suitable for use at 65 degree Celsius with an output that meets LPS requirements or PS2, with a rating of 54V DC (0.8A or 800mA minimum).

The following table shows the dimension of the grounding screw and lug.

Item 1 2 3 4 5 6 7 8
Tolerance W: ± 0.5 d2: ± 0.2 L: ± 0.5 F: ± 0.5 E: ± 0.5 d1: ± 0.2 D: ± 0.2 T: ± 0.5
Size 7.20 4.30 21.50 5.90 13.00 3.40 6.70 1.00
..