- Written by Kallol Mandal
- Posted on 3月 3, 2023
- Updated on 3月 7, 2023
- 1273 Views
In a VXLAN routing setup using VXLAN Controller Service (VCS), this feature will enable the following on a switch that is running as a VCS client.
- Written by Kallol Mandal
- Posted on 1月 3, 2023
- Updated on 1月 17, 2023
- 1507 Views
In a VXLAN routing setup using VXLAN Controller Service (VCS), this feature will enable the following on a switch that is running as a VCS client.
- Written by Kallol Mandal
- Posted on 4月 25, 2022
- Updated on 10月 28, 2022
- 3306 Views
Overlay IPv6 routing over VXLAN tunnel using an anycast gateway (direct routing) has been previously supported using the “ipv6 virtual-router” configuration for both the data-plane and EVPN (or CVX) control-plane learning environments.
- Written by Kallol Mandal
- Posted on 6月 21, 2021
- Updated on 10月 26, 2021
- 8082 Views
In the Centralized Anycast Gateway configuration, the Spines are configured with EVPN IRB and are used as the IP
- Written by Kallol Mandal
- Posted on 11月 14, 2019
- Updated on 12月 22, 2020
- 5290 Views
Starting with EOS release 4.22.0F, the EVPN VXLAN L3 Gateway using EVPN IRB supports routing traffic from one IPV6
- Written by Kallol Mandal
- Posted on 1月 17, 2019
- Updated on 1月 23, 2019
- 4827 Views
In certain VXLAN deployments with either NSX/Logical Router or EVPN IRB, active nodes hosting a virtual IP address
- Written by Kallol Mandal
- Posted on 1月 17, 2019
- Updated on 1月 23, 2019
- 4201 Views
Selective ARP install is the selective programming of remote ARPs in hardware as received through EVPN Type 2 MAC IP