Setting Up CV Applications
This section discusses the following topics:
Setting Up CVP
Note: Single-Node is not recommended for production deployments.
Pre-installation checklist
- Ensure that you have console access to the CVP virtual machine on each appliance, via WOK web access.
- Enter the CVP Console.
- Ensure all configurations are done via console and not via SSH.
Note: This configuration will change the IPs and will drop connectivity if done over SSH.
Setup Steps for Single Node CVP
Setup Steps for Multi-node CVP Cluster
Assign to each of the three CVP VMs a role (primary, secondary or tertiary).
- The roles may be assigned in any way, but the roles must be kept consistent throughout the installation. No two nodes may share the same role.
- Maintain the installation order starting with primary, then secondary and finally tertiary.
- Access the primary, secondary and tertiary CVP VMs on the respective appliance via WOK. See Web Access into CVX and CVP Consoles via WOK.
- Refer to the CloudVision Configuration Guide for Shell-Based Configuration of Multi-Node.
CloudVision Portal Login Page
After CVP is running on the multi-node appliance cluster, enter the CVP Web Interface of the primary node via its CVP IP/Hostname with default username/password of cvpadmin/cvpadmin to set the password.
For Multi-node clusters, setting the password only has to be done on one node, and will be synced to other nodes so subsequently any node can be accessed via its web interface. Refer to the CloudVision Configuration Guide for instructions on using CVP.
