Total 15 results found for the keyword of "eos multicast source discovery protocol"
multicast source discovery protocol (MSDP)
multicast source discovery
protocol (MSDP) describes a topology that connects multiple IPv4 protocol
Independent multicast Sparse-Mode (PIM-SM) domains. ...
protocol Independent multicast
(PIM) distributes multicast data using routes gathered by other protocols.
Arista switches support two types of PIM: PIM Sparse Mode (PIM-SM) ...
IP multicast is the transmission of data packets to multiple hosts through a common IP address. Sections covered in this chapter include:
IGMP and IGMP
IP multicast is the transmission of data packets to multiple hosts through a common IP address. Arista switches support multicast transmissions through IGMP, IGMP Snooping, ...
Spanning Tree protocol
Spanning Tree protocols prevent
bridging loops in Layer 2 Ethernet networks. Arista switches support
Rapid Spanning Tree, Multiple Spanning Tree, and Rapid-Per VLAN Spanning
This chapter describes VM Tracer
configuration and usage and contains these sections:
VM Tracer Introduction
VM Tracer Description
VM Tracer Configuration Procedures
VM Tracer ...
Audio Video Bridging
Arista switches support Audio Video Bridging (AVB) and the associated protocols. This section describes AVB concepts and the implementation of associated protocols.
EVPN Layer 3 Core Operations
The EVPN standard defines a number of operations and functionality to allow the dynamic learning of MAC and IP bindings, management of MAC moves (VM/host mobility), ARP ...
... it is binding a label.
Note: All connected interfaces are advertised as bound. However, eos currently advertised labels for /32 addresses, and FEC filter is configured to install only x.x.x.200/32 prefixes. ...
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... Across VRF
The eos DHCP relay agent supports forwarding of DHCP requests to DHCP servers located in a different VRF to the DHCP client interface VRF. In order to enable VRF support for the DHCP relay ...
... is a layer 2 feature that is configured on LAN switches. The Arista eos switch supports Option-37 insertion that allows relay agents to provide remote-ID information in DHCP request packets. DHCP servers ...
... mode as shown below.
(config)# management ssh
(config-mgmt-ssh)# ip access-group [vrf ] in
(config-mgmt-ssh)# ipv6 access-group [vrf ] in
In eos 4.19.0, all VRFs are required to use the same ...
MACsec encryption is a eos licensed feature. A valid MACsec license must be configured on a switch. MACsec licenses are tied to a switch serial number and the licensee. Every switch running MACsec ...
... full10G Not Present
Et4/7 connected1 full10G Not Present
Et4/8 connected1 full10G Not Present
Et4/9 connected1 full10G Not Present
Referencing Multi-lane Ports
eos supports two types of ...