Access Point Overview

The O-235 is a tri-radio (4X4 5GHz, 2X2 2.4GHz, 2x2 Dual-band scan radio), Wi-Fi 6 access point.

This chapter provides an overview of the O-235 and describes the:

Front Panel

The front panel of the O-235 has 6 LEDs that indicate the status of various device functions.

 

 

Figure 1. Front Panel LEDs


 

 

Table 1. Labels: Front Panel LEDs
Label Description
1 Power
2 2.4 GHz Radio
3 5 GHz Radio
4 Third Radio
5 LAN1
6 LAN2

 

Power LED: The following table describes the Power LED states.

 

Table 2. Power LED States Description
  Green Orange
Solid Running at full capability Running at reduced capability
Blinking Received IP address, but not connected to the server Did not receive an IP address

 

Reduced capability indicates that the AP is getting lower than the required maximum power from the PoE+ switch, i.e., 802.3af instead of 802.3at.

LAN1 LED: ON when the corresponding interface is up.

LAN2 LED: ON when the corresponding interface is up and wired guest or link aggregation is configured.

Radio LEDs: ON when the corresponding radio is operational.

Rear Panel

The rear panel of the AP has LAN/PoE+ connectors that enable you to connect the AP to a wired LAN through a switch or a hub. The ports provide power to the AP by using the 802.3at standard.

Figure 2. O-235 Rear Panel

 

 

Table 3. Labels: Ports
Label Description
1 LAN1 (PoE+)
2 LAN2

 

 

Table 4. O-235 Port Details
Port/Button Description Connector Type Speed/Protocol
LAN1 5 Gigabit Ethernet with 802.3at compliant PoE IP67-rated, weatherproof RJ-45 100/1000 Mbps Ethernet, 1/2.5/5 Gbps Ethernet
LAN2 1 Gigabit Ethernet with 802.3at compliant PoE IP67-rated, weatherproof RJ-45 100/1000 Mbps Ethernet

Side Panel

The side panel of the AP has a console port, a USB port, and a Reset pin.

Figure 3. Side Panel

 

 

Table 5. Labels: Side Panel
Label Description
1 Reset
2 USB
3 Console

 

 

Port Description Connector Type Speed/Protocol
Console

Establish ‘config shell’ terminal session via serial connection

 RJ-45
  • RS 232 Serial (115200 bits per second)
  • Data bits:8; Stop bits: 1
  • Parity: None
  • Flow Control: None
USB USB 2.0 port USB Future Use
Reset

Reset to factory default settings port. Hold down and power cycle the device to reset.

 Pinhole push button N/A

 

When you reset the AP, the following settings are reset:
  • Config shell password is reset to config.
  • The server discovery value is erased and changed to the default redirector.online.spectraguard.net (primary) and wifi-security-server (secondary).
  • All the VLAN configurations are lost.
  • If a static IP is configured on the AP, the IP address is erased and DHCP mode is set. The factory default IP address of the AP is 169.254.11.74.