Tag :: Configuration

When configuring the MAC address of a switch, CLI commands and REST endpoints will accept a MAC address formatted as three groups of four hexadecimal digits separated by periods (e.g. 1122.3344.5566) in addition to the already accepted form of six hexadecimal digit pairs separated by colons (e.g. 11:22:33:44:55:66). 

This article describes speed configuration for the management SFP port. DCS 7300 SUP2. DCS 7300 SUP2 D

In DMF 8.7.0,  the redesigned integration configuration now masks the password field and improves the configuration management. Use the Edit icon to Add, Modify, or Delete the Integration configuration.

Configuration of arbitrary combinations of speeds on subinterfaces is being restricted on 800G CMIS Arista transceivers. This feature restricts configuring only uniform sets of speeds on applicable transceivers. This affects Arista-branded 800G active optical transceivers.

If a gNMI.Set union_replace operation or gNOI.BootConfig RPC is issued without this configuration, an error is returned to the client.This feature adds support for the following to OpenConfig: gNMI.Set union_replace operation

The new show command show configuration consistency adds the ability to check for “dangling” references in the configuration. For example, it is possible to configure an access-list, TEST-ACL, to an interface (ip access-group TEST-ACL in), without actually defining TEST-ACL (ip access-list TEST-ACL). This show command will list such “undefined” references.