- Written by Subhash S
- Posted on 7月 2, 2024
- Updated on 11月 8, 2024
- 1520 Views
This feature adds support for associating a WAN interface with multiple Dynamic Path Selection (DPS) path groups to allow paths originating from the same interface to have different priorities.
- Written by Ravi Krishnamurthy
- Posted on 6月 5, 2023
- Updated on 6月 5, 2023
- 5101 Views
DPS (Dynamic Path Selection) provides the ability to select different paths for different types of traffic to optimize application performance.
- Written by Sarah Chen
- Posted on 10月 17, 2024
- Updated on 10月 17, 2024
- 474 Views
This feature is used to connect a Layer 3 EVPN VXLAN network to an Adaptive Virtual Topology (AVT) WAN network using dynamic path selection (DPS) tunnels. One or a pair of WAN routers are configured to serve as the VXLAN gateway. On the control plane, the configured VXLAN gateway handles EVPN IP-PREFIX route exchanges between the VXLAN network and the WAN network. On the data plane, the configured VXLAN gateway decapsulates the VXLAN packets received from the VXLAN network and encapsulates them into the DPS tunnels and sends them to the AVT WAN network.
- Written by Harsimran
- Posted on 6月 5, 2023
- Updated on 6月 5, 2023
- 4279 Views
STUN (Session Traversal Utilities for NAT) is a client-server protocol that can be used by a network endpoint to determine the IP address and port assigned to it by a NAT device. The protocol is defined in RFC8489.
This document describes the STUN client and server capabilities in CloudEOS, and how this is used by Dynamic Path Selection (DPS) feature.