- Written by Arpit Bansal
- Posted on January 6, 2023
- Updated on January 6, 2023
- 1900 Views
For MPLS forwarded traffic the tunnel destination needs to know the address-family of the payload IP/IPv6 packet to correctly parse the header. On some platforms this address-family is deduced from the address family of the Bottom of stack( BOS ) MPLS label seen by the router or by relying on the Ether Type in the Ethernet header.
- Written by Jeff Hornsberger
- Posted on December 16, 2020
- Updated on April 19, 2022
- 4468 Views
LSPs formed by LDP normally follow IGP routing. The LDP speaker selects the downstream LSR for a particular prefix as
- Written by Paul Miiller
- Posted on December 15, 2021
- Updated on December 15, 2021
- 3344 Views
This feature adds a new CLI command which can be used to clear RSVP sessions. Clearing a session will remove the current
- Written by Kalash Nainwal
- Posted on December 14, 2020
- Updated on August 24, 2023
- 6722 Views
RSVP-TE, the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE), is used to distribute MPLS labels for steering traffic and reserving bandwidth. The Label Edge Router (LER) feature implements the headend functionality, i.e., RSVP-TE tunnels can originate at an LER which can steer traffic into the tunnel.
- Written by Martin Stigge
- Posted on September 16, 2020
- Updated on January 11, 2022
- 5196 Views
RSVP TE, the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE), is used to distribute MPLS labels
- Written by Martin Stigge
- Posted on October 22, 2018
- Updated on August 24, 2023
- 5803 Views
RSVP TE applies the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE), i.e., to distribute MPLS
- Written by Dragos Maftei
- Posted on December 16, 2021
- Updated on December 16, 2021
- 3478 Views
This feature adds RSVP information for three tables from MPLS TE STD MIB:. mplsTunnelTable.