◄
►

Perform Remote Actions

You can perform actions like Restarting services, Rebooting, or deactivating an Edge remotely, from the Enterprise portal.

You can perform the remote actions only on Edge that are in Connected state.

To perform the remote actions:

  1. In the Enterprise portal, you can perform the remote actions for an Edge using the Shortcuts option available in the Configure > Edges or Monitor > Edges pages. For more information, see Configure Edge Overrides and Monitor Edges in the Arista VeloCloud SD-WAN Administration Guide.
  2. Select the Shortcuts > Remote Actions to open the Remote Actions dialog.
    Figure 1. Remote Actions
  3. You can perform the following actions:
    Table 1. Remote Actions and Descriptions
    Action Description
    Identify Randomly flash lights on the selected Edge to identify the device.
    Restart Service Restarts the VeloCloud SD-WAN services on the selected Edge.
    Reboot Reboots the selected Edge.
    Shutdown Powers off the selected Edge. To restore the Edge, you must remove the power cable, and then plug it back into the Edge.
    Deactivate Resets the device configuration to its factory default state.
    Force HA Failover Forces HA Failover. This option is available only when the Edge is configured with High Availability and the state is HA ready.
    Note: The actions may take up to a minute to run on the device.