- Written by Kulwinder Singh
- Posted on 8月 16, 2018
- Updated on 9月 12, 2024
- 8211 Views
The feature allows to create a named TC to DSCP mapping that can be applied on an interface.DSCP of routed packets egressing out of the interface will be rewritten according to the map.
- Written by Alton Lo
- Posted on 9月 26, 2023
- Updated on 9月 26, 2023
- 4540 Views
EVPN route advertisements carry RD and RT. RD (Route Distinguisher) : prepend to the tenant’s IP Prefix or MAC address to make it globally unique. RT (Route Target) : a BGP extended community used to tag the EVPN route. The EVPN import policy is chosen to select what is the target tenant VRF is imported from the global EVPN table.
- Written by Prakrati Vidyarthi
- Posted on 8月 16, 2018
- Updated on 11月 5, 2024
- 15438 Views
Normally, a switch traps L2 protocol frames to the CPU. However, certain use-cases may require these frames to be forwarded or dropped. And in cases where the L2 protocol frames are forwarded (eg: Pseudowire), we may require the frames to be trapped to the CPU or dropped. The L2 Protocol Forwarding feature provides a mechanism to control the behavior of L2 protocol frames received on a port or subinterface.
- Written by Dawon Lee
- Posted on 8月 17, 2018
- Updated on 7月 5, 2024
- 8618 Views
Lanz Mirroring feature allows users to automatically mirror traffic queued as a result of congestion to either CPU or a different interface.
- Written by Zackary Ayoun
- Posted on 9月 5, 2019
- Updated on 9月 5, 2019
- 7376 Views
This document describes the latest status of LANZ on DCS 7500R, DCS 7280R and DCS 7020R, for both polling and notifying
- Written by Wade Carpenter
- Posted on 8月 16, 2018
- Updated on 5月 22, 2024
- 8020 Views
IP traceroute and path MTU (PMTU) discovery both require that routers send ICMP reply messages to the host that invokes each network function. When the route to the destination host traverses an MPLS label-switched path (LSP), the label switching routers (LSRs) will also need to send ICMP reply messages to the originating host.
- Written by Corey Hines
- Posted on 8月 17, 2018
- Updated on 11月 19, 2024
- 8596 Views
Priority Flow Control is a link-layer flow control mechanism which may be used by an overwhelmed network node to ask its transmitters to stop transmission for a specified period of time. It does so by using special frames known as PFC frames, thus, relieving congestion at the receiver node. With respect to this behavior, PFC is very similar to Link Layer Flow Control ( LLFC ), however, unlike LLFC, PFC allows the overwhelmed node to specify which 802.1Q Class of Service ( CoS ) it wants to stop receiving traffic for. Thus, allowing differentiated treatment of traffic based on CoS.