- Written by Haomin
- Posted on 11月 18, 2026
- Updated on 11月 18, 2026
- 14 Views
Although the CLI typically prevents invalid configuration, it is possible to configure NAT in a way that, while being valid from the CLI’s perspective, is problematic or sub-optimal. The way the user is informed about such scenarios is through the ability to check for NAT configuration consistency, the focus of this TOI
- Written by Ashit Tandon
- Posted on 11月 6, 2025
- Updated on 7月 1, 2026
- 2251 Views
Static NAT allows a switch to modify the source or destination IP address, and optionally the Layer 4 port, of packets traversing it. Each static NAT rule is explicitly defined by the user and specifies a one-to-one mapping between an original IP address and a translated IP address.
- Written by David Dombai
- Posted on 4月 27, 2026
- Updated on 4月 30, 2026
- 992 Views
Dynamic NAT is a feature which dynamically allocates an IP address to an incoming or outgoing flow. This address will replace source or destination IP for all packets of the flow. The new IP address given to the flow is from a pool of addresses called NAT pool. L4 port can also be replaced by a new one in case of NAPT (Network Address Port Translation). In address only NAT only the IP address is translated. NAPT is not supported in masquerade or overload mode.
- Written by Ashit Tandon
- Posted on 5月 5, 2025
- Updated on 7月 13, 2026
- 4218 Views
Dynamic Twice NAT is a variant of the dynamic NAT feature where both the source and destination IP can be modified while forwarding a packet. One of the IP addresses will be dynamically assigned, while the other will be statically assigned.
