- Written by Prateek Mali
- Posted on 8月 19, 2020
- Updated on 2月 28, 2024
- 14885 Views
Access Control Lists (ACL) use packet classification to mark certain packets going through the packet processor pipeline and then take configured action against them. Rules are defined based on various fields of packets and usually TCAM is used to match packets to rules. For example, there can be a rule to match the packet source IP address against a list of IP addresses, and drop the packet if there is a match. This will be expressed in TCAM with multiple entries matching the list of IP addresses. Number of entries is reduced by masking off bits, if possible. TCAM is a limited resource, so with classifiers having a large number of rules and a big field list, TCAM runs out of resources.
- Written by Shelly Chang
- Posted on 1月 6, 2022
- Updated on 2月 7, 2024
- 5517 Views
This feature introduces hardware forwarding support of IPv4 multicast traffic over IPv4 GRE tunnel interfaces in Arista Switches. Multicast source traffic can reach the receivers which are separated by an IP cloud which is not configured for IP multicast routing by utilizing a GRE tunnel.
- Written by James Brinkley
- Posted on 4月 25, 2022
- Updated on 1月 5, 2023
- 6600 Views
SWIM (SWI Modularized) is a change to the format of EOS.swi. It is a feature that is mostly internal, but has a few customer visible side-effects one should be mindful of.
- Written by Prasanna Parthasarathy
- Posted on 12月 23, 2021
- Updated on 2月 7, 2024
- 9051 Views
SwitchApp is an FPGA based feature available on Arista’s 7130LB-Series and 7132LB-Series platforms. It performs ultra low latency Ethernet packet switching. The port to port latency is a function of the selected SwitchApp profile. Detailed latency measurements are available in the userguide on the Arista Support site.
- Written by Anirudh Ramesh Iyer
- Posted on 5月 5, 2021
- Updated on 9月 4, 2023
- 12987 Views
This article describes how to customize TCAM ( Ternary Content Addressable Memory ) lookup for each feature which uses TCAM.
- Written by Isidor Kouvelas
- Posted on 2月 28, 2022
- Updated on 2月 2, 2024
- 10713 Views
Virtual Private LAN Service (VPLS) appears in (almost) all respects as an Ethernet type service to customers of a Service Provider (SP). A VPLS glues together several individual LANs across a packet switched network to appear and function as a single bridged LAN.
- Written by Simon Liang
- Posted on 9月 5, 2021
- Updated on 2月 26, 2024
- 5722 Views
This document describes the VRF selection policy and VRF fallback feature. A VRF selection policy contains match rules that specify certain criteria (e.g. DSCP, IP protocol) as well as a resulting action to select a VRF in which to do the FIB lookup.