- Written by Rashid Akhtar
- Posted on March 3, 2023
- Updated on March 17, 2023
- 5345 Views
This document describes the CLI introduced to change the default hardware FEC allocation scheme for IPv4/IPv6 attached routes. By default, level2 hardware FECs are allocated for attached IPv4/IPv6 routes. To change the default hardware FEC allocation scheme, this CLI can be used.
- Written by Mike Nelson
- Posted on October 20, 2021
- Updated on December 20, 2021
- 8168 Views
Tagging traffic with a drop precedence is a method that can be used to differentiate traffic flows over a given
- Written by Mason Alexander Flowers
- Posted on January 3, 2023
- Updated on January 17, 2023
- 5961 Views
This feature introduces the show bgp evpn sanity ( brief | detail )command. This command displays which EVPN configuration attributes are inconsistent as well as potential errors in the EVPN operational state.
- Written by Vishal Bandekar
- Posted on August 23, 2022
- Updated on August 21, 2024
- 6207 Views
This document is an extension to the decap group feature, that allows IPv4 addresses to be configured and used as part of a group. Now we will be able to configure IPv4 prefixes as a decap group.
- Written by Jian Zhen
- Posted on December 18, 2019
- Updated on December 27, 2021
- 7996 Views
The document describes an extension of the decap group feature, that allows IPv6 addresses to be configured and used
- Written by Ryan Halbrook
- Posted on January 10, 2020
- Updated on January 10, 2020
- 7979 Views
This feature provides multipath router id, a new multipath mode to control the behavior of RPF selection. In the
- Written by Ryan Halbrook
- Posted on June 28, 2021
- Updated on June 28, 2021
- 8478 Views
Multipath color is a new multicast multipath mode for controlling PIM RPF selection. In the default multipath
- Written by Mingchao Lian
- Posted on September 11, 2024
- Updated on September 11, 2024
- 742 Views
In order to support PIM/IPv4 multicast routing on EOS switches with Broadcom Tomahawk4 ASICs, multicast support using ALPM is required. This works in both 3-level Algorithmic Longest Prefix Match (ALPM) capabilities and 2-level ALPM.
- Written by Leighton Carmichael-Powell
- Posted on January 3, 2023
- Updated on July 14, 2023
- 5898 Views
This document describes the prefix counter feature and is intended for customers who are familiar with and are using VRF selection policies (see linked TOI for details). In short, the prefix counter feature enables traffic matching a VRF selection policy to be counted on a per-prefix/per-route basis. This is limited to IPv4 traffic and prefixes of length 32.