Total 6 results found for the keyword of "eos section 15 2 configuring macsec"
LDP Pseudowire
LDP pseudowire provides support for emulating Ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
... STP state. When an interface used as an Ethernet segment does not have a forwarding
state, eos considers the interface to be inactive. For a VLAN-based service, the port must be in a forwarding state
on ...
... Mac Address Type Ports
---- ----------- ---- -----
Total Mac Addresses for this criterion: 0
Beginning with eos Release 4.26.0F,
PortSec-Protect enforces a limit on ...
...
configuring Priority-Flow-Control (PFC)
configuring PFC Watchdog
DCBX and Flow Control Commands
Introduction
eos implements Link Layer Discovery
Protocol (LLDP) and the Data Center Bridging ...
Layer 2 Protocol Forwarding
eos supports Layer2 (L2) Protocol Forwarding on Ethernet interfaces in addition to
Type-5 PW. Also, eos allows selective forwarding of certain L2 Protocol packets, such ...
... eXtended Packet Numbering (XPN) cipher suites.
macsec Limitations
The following are the limitations of macsec:
eos supports macsec only on point-to-point links unless static SAK is ...