Total 14 results found for the keyword of "eos section 36 3 decap groups"
decap groups
These sections describe the decap groups features:
decap groups Overview
Configuring decap groups
Configuring Generic UDP Encapsulation (GUE) decap groups
decap groups Commands
...
... Group).
These commands set the next-hop group size at four entries, then create three
entries. eos drops packets hashed to the fourth
entry.switch(config)# nexthop-group NH-1
switch(config-nexthop-group-NH-1)# ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
EVPN Multicast VRF Leaking
Overview
EVPN Multicast virtual routing and forwarding (VRF) Leaking forwards multicast
traffic from a sender in a tenant or external domain (VRF) to a different domain
(VRF) ...
...
eos adds a new parameter in the output, evpn prefix detail to display the
ATTR_SET, code 128 attributes.
switch#show bgp evpn
BGP routing table information for VRF default
Router identifier 10.11.0.1, ...
Multiprotocol Label Switching (MPLS)
Tunneling protocols encapsulate packets of a different protocol as the payload of a
larger frame for delivery within networks utilizing the encapsulating protocol.
Tunneling ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
VXLAN Description
These sections describe VXLAN architecture, the data objects that comprise a VXLAN network, and
process of bridging packets through a VXLAN network.
VXLAN Architecture
VXLAN Gateway ...
... VRF blue.
switch(config)# router msdp
switch(config-router-msdp)# vrf blue
switch(config-router-msdp-vrf-blue)# peer 1.1.1.1
Configuring MSDP TCP Authentication
eos supports Multicast ...
Layer 3 Configuration
This chapter covers the following Layer 3 sections:
IPv4
IPv6
Ingress and Egress Per-Port for IPv4 and IPv6 Counters
ACLs and Route Maps
VRRP and VARP
DirectFlow
decap ...
... detection
disabled command detects any
duplicate IP address on the interface. When the switch
detects the duplicate IP address, eos generates a syslog
message. It helps the network operator to identify ...
... that are configured by a custom agent using the eos SDK or eAPI
and age out (expire) after a specified time period.
For example, if you are using a custom agent that reacts to traffic sent to the CPU ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
... port_number - Specify a local interface and port. eos supports the following interfaces:
Backplane-Channel
Ethernet
Fabric
Loopback
Management
Port-Channel
Recirc-Channel
Tunnel
Vlan ...