Total 46 results found for the keyword of "eos section 38 6 multicast commands"
EVPN and VCS commands
Global Configuration Mode
router
general
Router BGP Configuration Mode
next-hop
resolution disabled
redistribute
service vxlan
route-target
route-target
export
route-target ...
VXLAN commands
VXLAN Global Configuration
commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface Configuration
commands
igmp snooping
vxlan flood vtep ...
... router msdp
switch(config-router-msdp)# vrf blue
switch(config-router-msdp-vrf-blue)# peer 1.1.1.1
Configuring MSDP TCP Authentication
eos supports multicast Source Discovery Protocol (MSDP) peering ...
... interface vlan 8
switch(config-if-Vl8)# pim ipv4 sparse-mode
switch(config-if-Vl8)#
Enabling PIM IPv6 Sparse Mode
By default, eos disables IPv6 PIM disabled on an interface. The pim ipv6 sparse-mode ...
... Beginning with eos Release 4.25.0F, MLDv2 snooping is supported on MLAG deployments.
Limitations
The extraneous “Switch” interface should be ignored in show mld
snooping counters and show mld snooping
counters ...
... version of the command
to delete the GM list. If no list exists, eos considers all potential GM clocks by
default.
To delete a single clock, use the no ptp grandmasters clock-identity accepted address_format. ...
... values: 0, boundary_value, infinity.
At most, 4 bins can be specified using 0, infinity, and 3 boundary values.
If you do not configure a binning profile, eos uses the following default profile:
binning ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer Configuration Procedures
VM Tracer commands ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... single agent, but supports additional agents to allow multiple CPUs and increase the total number of packets processed. eos
supports up to 8 SFTAgents.
Use the following command to add 3 instances of ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
Configuring RSVP-TE P2MP Tunnels
RSVP-TE P2MP Tunnels adds support for Point-to-Multipoint (P2MP) tunnels to be used in
multicast Virtual Private Network (MVPN).
There are two major parts to the ...
... vrf vrf-blue
switch(config-router-bgp-vrf-vrf-blue)# rd 2:2
switch(config-router-bgp-vrf-vrf-blue)# route-target import evpn 10:1
Importing BGP Route Target Ranges for VRFs
eos supports BGP route ...
...
eos adds a new parameter in the output, evpn prefix detail to display the
ATTR_SET, code 128 attributes.
switch#show bgp evpn
BGP routing table information for VRF default
Router identifier 10.11.0.1, ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
Ethernet VPN (EVPN)
This chapter describes the Arista EVPN implementation. sections in this chapter
include the following topics:
EVPN Overview
EVPN Layer
3 Core Operations
Integrated Routing and ...
...
VXLAN Decapsulation for interface with multiple VRFs
Please refer to the following security advisory after the eos software upgrade for a
network that leverages VXLAN decapsulation on an interface ...
VXLAN Description
These sections describe VXLAN architecture, the data objects that comprise a VXLAN network, and
process of bridging packets through a VXLAN network.
VXLAN Architecture
VXLAN Gateway ...
Audio Video Bridging
(AVB)
Arista switches support Audio Video Bridging (AVB) and the associated protocols. This section
describes AVB concepts and the implementation of associated protocols.
Topics ...
... list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified RIB domains, overriding the default behavior. Further, ...