Total 12 results found for the keyword of "eos section 39 4 configuring igmp snooping"
... Features - When running ASU, eos does not support the following features:
Multi-Chassis Link Aggregation (MLAG)
EVPN Multicast
PIM Bidirectional (PIM-BiDir)
Peer Switch Release Requirement - The ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
VXLAN Commands
VXLAN Global Configuration
Commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface Configuration
Commands
igmp snooping
vxlan flood vtep ...
... Beginning with eos Release 4.25.0F, MLDv2 snooping is supported on MLAG deployments.
Limitations
The extraneous “Switch” interface should be ignored in show mld
snooping counters and show mld snooping
counters ...
... interface vlan 8
switch(config-if-Vl8)# pim ipv4 sparse-mode
switch(config-if-Vl8)#
Enabling PIM IPv6 Sparse Mode
By default, eos disables IPv6 PIM disabled on an interface. The pim ipv6 sparse-mode ...
IPv6
eos supports Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6) for
routing packets across network boundaries. This section describes Arista’s implementation of
IPv6 and ...
... syntax is the industry standard.
Note: eos supports egress IPv4 and IPv6 Port Access Control Lists
(PACLs) by default. To enable egress MAC PACLs, add the configuration to the current TCAM
profile. ...
... that are configured by a custom agent using the eos SDK or eAPI
and age out (expire) after a specified time period.
For example, if you are using a custom agent that reacts to traffic sent to the CPU ...
... must arrive on the parent interface
with the configured tag to be processed by the subinterface.
Routed Parent Port
eos typically creates Layer 2 subinterfaces on a routed
port,an interface configured ...
... Configuration
Procedures
VLAN Configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
Event Monitor
The Event Monitor writes system event records to local files for access by SQLite database
commands.
Note:The switch does not enable event-monitor by default. Use the event-monitor
command ...
... values: 0, boundary_value, infinity.
At most, 4 bins can be specified using 0, infinity, and 3 boundary values.
If you do not configure a binning profile, eos uses the following default profile:
binning ...