Total 12 results found for the keyword of "eos section 6 7 switch administration commands"
... values: 0, boundary_value, infinity.
At most, 4 bins can be specified using 0, infinity, and 3 boundary values.
If you do not configure a binning profile, eos uses the following default profile:
binning ...
Administering the switch
This chapter describes administrative tasks typically performed only after initially configuring
the switch or after recovery procedures.
This chapter includes these sections:
Managing ...
... (DCS-7150S-64-CL, eos-4.13.2F)
!
vlan 3-4
!
username john secret 5 $1$a7Hjept9$TIKRX6ytkg8o.ENja.na50
!
hostname sales1
ip name-server vrf default 172.17.0.22
dns domain samplecorp.org
!
end
switch# ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
... control access to eos commands. Three data services conduct authentication, authorization, and accounting (AAA) activities: a local security database, TACACS+ servers, and RADIUS servers.
The Configuring ...
... the Time Zone
eos uses a fundamental system clock based on UTC and you cannot change the system clock UTC base. Instead, configure the time zone and eos converts the UTC base time to the local time ...
... CLI Prompt
The CLI prompt provides an entry point for eos commands. The prompt command configures the contents of the prompt.
The no prompt command returns the prompt to the default of
%H%P.
Characters ...
System Event Logging
Arista switches log Event Notifications using the Syslog protocol. By
default, eos logs the event notifications internally to the folder,
/var/log/messages but can also display ...
Event Monitor
The Event Monitor writes system event records to local files for access by SQLite database
commands.
Note:The switch does not enable event-monitor by default. Use the event-monitor
command ...
Monitoring Latency
The Monitoring Latency feature allows the measurement and display of end-to-end packet
latency as seen at egress interfaces. eos measures packet latency from switch ingress to
switch ...
7130 Platform Layer 1 Configuration
This section describes the purpose, behavior, and configuration of the 7130 platform and includes the following topics:
Configuring Layer 1 on 7130 Platform
Interface
Addressing ...