Total 14 results found for the keyword of "eos section 7 6 aboot configuration commands"
... the password from the encrypted string. If the
clear-text password is lost, delete the corresponding
PASSWORD command line from the
boot-config file.
Note:
The eos boot secret command adds or
modifies ...
Session Management commands
Global configuration commands
commit timer
configure replace
configure session
management api eos-sdk-rpc
management api external-services
management api gnmi
management ...
...
When the switch is powered on or rebooted, aboot reads its configuration from
boot-config on the internal flash and attempts
to boot a configured eos software image (with the extension
.swi).
You can ...
... not know the current settings, restore the factory default
settings described in Restoring the Factory Default eos Image and Startup configuration.
The no boot console and default boot console commands ...
... changed since the last boot.
boot-config
The boot-config file is an ASCII file that aboot uses to configure console
communication settings, locate the eos flash image, and specify
initial network ...
... distributes operational state information across a set of eos switches to support applications that provide network services. See the CloudVision User Guide, https://www.arista.com/en/support/product-documentation, ...
... upgrade method if you have VRRP
configured on the switch.
Upgrading the eos image with Smart System
Upgrade
Using SSU to upgrade the active eos image requires a five-step process:
Preparing the ...
Standard Upgrades and Downgrades
Standard software upgrades and downgrades on Arista switches are accomplished by installing a
different eos image and reloading the switch. On switches with redundant ...
... 1.9.0-52504.eos2.0
Press Control-C now to enter aboot shell
To continue the reload process, do nothing. Typing Ctrl-C opens the
aboot shell; see aboot commands for
aboot editing instructions.
...
... secure provisioning, you must ensure that only approved DHCP servers can
communicate with the switch until after completing the ZTP process. Arista also
recommends validating the eos image on your ZTP ...
... same mount point with the same
options. Boot the eos again by installing a new boot-config file and and eos SWI, then
rebooting using aboot or fullrecover.
All secure erasing is best effort. Use firmware-based ...
... configuration
Restoring the Factory Default eos Image and Startup configuration
USB Support for ZeroTouch Provisioning
Restoring the configuration and Image from a USB Flash Drive
The first three ...
... CLI.
This chapter includes these sections:
Accessing the eos CLI
Processing commands
Kernel-based Virtual Machine commands and configuration
Switch Platforms
Command Modes
Managing Switch
configuration ...
Booting the Switch
This chapter describes the
switch boot process, describes configuration options, and lists the components
it requires, including the boot loader, the boot loader shell, and other
configuration ...