Maintenance and Field Replacement
Only the fan module is field replaceable.
Note: Hot-swap or reorient fans within one minute to prevent the switch from overheating and shutting down.
Ensure that the module you replace matches those already installed in the switch.
Considerations
- The fan module is hot-swappable and can be reoriented for airflow direction.
- The switch will shut down if the fan module is disconnected for more than a minute.
- Before you begin, refer to the Arista Networks document Safety Information and Translated Safety Warnings at: https://www.arista.com/en/support/product-documentation.
Removing a Fan Module
The following steps are required when removing or replacing fans from a switch.
- Ground yourself with an ESD wrist strap.
- While squeezing the fan module handle, pull the fan module out of the switch.
Installing a Fan Module
You must make space for installing the fan module by removing an existing one (Removing a Fan Module).
- Remove the replacement fan from its packaging.
- Slide the new fan module into the switch until the module is fully seated and the release lever snaps into place.
- Verify that the fan module is working normally.
Note: The fan module status LED should be a steady green for normal operation.