Tag :: 4.23.2F

Adds the ability to revert to previous behavior where BGP and static routes could resolve over BGP aggregates (when

The CPU CoS mapping feature can only be configured on physical routed interfaces. No other interface types including

MPLS LDP traceroute utility has now been extended to support multipath traceroute. This allows network

Add support for configuring admin distance for OSPFv3 external routes, without this OSPFv3 would always install

QSFP+ transceiver supports 40G and 4x10G. This feature provides support for changing the default QSFP mode between

In the Centralized Anycast Gateway configuration, the Spines are configured with EVPN IRB and are used as the IP

This feature adds control plane support for inter subnet forwarding between EVPN and IPVPN networks. It also

This feature enables support for an EVPN VxLAN control plane in conjunction with Arista’s OpenStack ML2 plugin for

Forwarding destination prediction enables visibility into how a packet is forwarded through the switch, allowing you to determine which interface(s) a packet would egress out of. This feature has been expanded upon with support for packets specified as a byte stream, allowing you to fully specify the packet.

IP Locking is an EOS feature configured on an Ethernet Layer 2 port.  When enabled, it ensures that a port will only permit IP and ARP packets with IP source addresses that have been authorized. As of EOS-4.25.0F release update, IP locking can run in two modes - IPv4 Locking (which will be referred to as IP Locking) and IPv6 Locking, which can be configured using the commands mentioned in the below sections. IP Locking prevents another host on a different interface from claiming ownership of an IP address through either IP or ARP spoofing.

This article describes the support for specifying DSCP mask in IPv4 access list. DSCP mask can be used to match

Introduced in EOS-4.20.1F, “selectable hashing fields” feature controls whether a certain header’s field is used in the hash calculation for LAG and ECMP.

This article describes speed configuration for the management SFP port. DCS 7300 SUP2. DCS 7300 SUP2 D

This feature enables per port TC-To-COS mapping, where TC represents Traffic-Class and COS represents Vlan tag PCP bits. While at present there is a global TC-To-COS mapping, we can use the TC-To-COS feature to create custom profiles which can be applied to the required interfaces. 

This article describes the support for specifying User Defined Fields(UDF) in Port ACLs including IPv4, IPv6, and

This document describes the feature that allows redistribution of routes from ISIS to OSPFv3 running on a device.

This feature allows routes that were leaked from one VRF (the source VRF) into another VRF (the destination VRF) using

This feature adds support for ‘match interface’ clause under route map config for Bgp policy application in

EOS 4.21.3F introduces support for BGP Flowspec, as defined in RFC5575 and RFC7674. The typical use case is to filter or redirect DDoS traffic on edge routers.

4.23.2F release supports reading and streaming various OpenConfig configuration and state models over gNMI (gRPC

When a high speed serial communication link is established, the two ends communicate with each other over a

The Tap Aggregation timestamping feature supports both timestamping packets in TAI (International Atomic Time)