Total 50 results found for the keyword of "eos 11 5 port"
... of the LDP
neighbor for which it is binding a label. Note: All connected interfaces are
advertised as bound. However, eos currently advertised labels for /32 addresses, and
FEC filter is configured ...
Support for Layer 3 MTU on 7280R3/7500R3/7800R3
7280R3/7500R3/7800R3 switches support Layer 3 Maximum Transmission Unit (MTU) with the
following features:
These switches enforce the MTU for Layer ...
Ingress and Egress Per-port for IPv4 and IPv6 Counters
This feature supports per-interface ingress and egress packet and byte counters for IPv4 and IPv6.
This section describes Ingress and Egress ...
Octal port Renumber to Four Interfaces
For an octal port such as a QSFPDD or OSFP, this feature renumbers the ports on a
system to have 4 configurable interfaces instead of eight. The original octal ...
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
Setting the PTP Transport Type
To set the PTP transport type, use the ptp
transport command.
This command configures the PTP transport type for the interface to IPv4.
switch(config-if-Et5)# ptp transport ...
... can be enabled or disabled on the
fly without impacting regular packet forwarding functionality.
NDR Switch Sensor Extension
NDR switch sensor extends eos telemetry for network threat detection. The ...
... as Signal-To-Noise Ratio, Residual Inter Symbol Interference, PAM4 Level Transition Parameters, and other parameters supported on optics interfaces.
Using the Performance Monitoring feature allows eos ...
... clusters. This means the directly connected
TaskTracker nodes can belong to different clusters. eos supports a maximum of five
clusters per switch.
MapReduce Tracer Configuration
The MapReduce Tracer ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer Configuration Procedures
VM Tracer Commands ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... template interval 3400000
Hardware Flow Tracking with IPFIX Export
Hardware Flow Tracking uses match criteria to collect data from packets based on defined
flow profiles. eos sends the collected ...
Latency Analyzer (LANZ)
Arista Networks’ Latency Analyzer (LANZ) is a family of eos features that provide enhanced
visibility into network dynamics, particularly in areas related to the delay packets
experience ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
...
Examples
In this example, eos sends hello messages to all known neighbors every
10 seconds. If the switch does not receive
hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses
communication ...
LDP Pseudowire
LDP pseudowire provides support for emulating Ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
RSVP-TE LER
RSVP-TE, the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE),
distributes MPLS labels for steering traffic and reserving bandwidth. The Label Edge
Router (LER) feature ...
RSVP-TE LSR
RSVP-TE applies the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE) to distribute MPLS labels for steering traffic and reserving bandwidth.
The eos implementation supports ...