Total 50 results found for the keyword of "eos 34 3 multicast configuration"
EVPN multicast VRF Leaking
Overview
EVPN multicast virtual routing and forwarding (VRF) Leaking forwards multicast
traffic from a sender in a tenant or external domain (VRF) to a different domain
(VRF) ...
...
VXLAN Decapsulation for interface with multiple VRFs
Please refer to the following security advisory after the eos software upgrade for a
network that leverages VXLAN decapsulation on an interface ...
... Beginning with eos Release 4.25.0F, MLDv2 snooping is supported on MLAG deployments.
Limitations
The extraneous “Switch” interface should be ignored in show mld
snooping counters and show mld snooping
counters ...
... interface vlan 8
switch(config-if-Vl8)# pim ipv4 sparse-mode
switch(config-if-Vl8)#
Enabling PIM IPv6 Sparse Mode
By default, eos disables IPv6 PIM disabled on an interface. The pim ipv6 sparse-mode ...
multicast Source Discovery Protocol (MSDP)
multicast Source Discovery Protocol (MSDP) describes a topology that connects multiple IPv4 Protocol Independent multicast Sparse-Mode (PIM-SM) domains. ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer configuration Procedures
VM Tracer ...
... num - The value that is multiplied by the interval value.
Examples
In this example, eos sends hello messages to all known neighbors every 10 seconds. If the switch does not receive ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... template interval 3400000
Hardware Flow Tracking with IPFIX Export
Hardware Flow Tracking uses match criteria to collect data from packets based on defined
flow profiles. eos sends the collected ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
Configuring RSVP-TE
The configuration of RSVP-TE requires the configuration of one or more of the following:
Configuring RSVP-TE LER
Configuring RSVP-TELSR
Configuring RSVP-TE P2MP LER ...
... to the same ES where they originated. To overcome this, eos includes ESI
labels to Non-DF PEs as well. This shared ESI label provides a mechanism to achieve sending an
ESI label to Non-DF PEs on platforms ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
EVPN and VCS Commands
Global configuration Mode
router
general
Router BGP configuration Mode
next-hop
resolution disabled
redistribute
service vxlan
route-target
route-target
export
route-target ...
VCS to EVPN Hitless Migration
VCS to EVPN Hitless Migration enables support for migrating from only using VCS as
the control plane to only using EVPN as a control plane in a hitless manner concerning ...
... mechanisms in eos and the broader use-cases they support are documented here:
Inter-VRF Local Route Leaking using BGP VPN
Inter-VRF Local Route Leaking using VRF-leak Agent
configuration
The ...
... the advertising router ID, along with the extended
communities of tunnel type (MPLS), MPLS Label value and
route-target.
Note: You require Release eos 4.21.1F and later versions with Jericho/Jericho+
platforms. ...
VXLAN Commands
VXLAN Global configuration
Commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface configuration
Commands
vxlan flood vtep
vxlan multicast-group ...
Ethernet VPN (EVPN)
This chapter describes the Arista EVPN implementation. Sections in this chapter
include the following topics:
EVPN Overview
EVPN Layer
3 Core Operations
Integrated Routing and ...
... of the LDP
neighbor for which it is binding a label. Note: All connected interfaces are
advertised as bound. However, eos currently advertised labels for /32 addresses, and
FEC filter is configured ...