Total 10 results found for the keyword of "eos 9 3 maintenance mode features"
eos 4.33.2F User Manual - maintenance mode
...  maintenance mode Configuration maintenance mode Commands Overview Using maintenance mode, you can perform several maintenance activities, such as: eos image upgrade. Initial configuration ...
eos 4.33.2F User Manual - MPLS Commands
...  Examples In this example, eos sends hello messages to all known neighbors every 10 seconds. If the switch does not receive hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses communication ...
eos 4.33.2F User Manual - Open Shortest Path First-Version 3
... area and interface levels. Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another ...
eos 4.33.2F User Manual - IS-IS
... in section 2.1.1.2 of RFC8667. The following enhancements are available by release: eos Release 4.22.1F adds support for TI-LFA backup paths that protect IS-IS SR labeled traffic corresponding to a ...
eos 4.33.2F User Manual - Border Gateway Protocol (BGP)
... This allows eos to direct specific services over the specified RIB domains, overriding the default behavior. Further, this feature, through the use of user-defined tunnel RIBs, empowers an administrator ...
eos 4.33.2F User Manual - Open Shortest Path First-Version 2
... OSPFv2 adjacencies with DR Other neighbors. OSPFv2 Multiple Instances Support eos Release 4.22.1F adds support for multiple OSPFv2 instances to be configured in the default VRF. OSPFv2 Multiple Instances ...
eos 4.33.2F User Manual - Traffic Management
... SR Policy IdentificationThe following identifies an SR policy. Endpoint - An IPv4 or IPv6 address which refers to the destination of the policy. eos allows 0/0 and 0:: and calls these IP addresses null ...
eos 4.33.2F User Manual - Ethernet Ports
... command for shutting down the Tx output path for unidirectional mode. 1-second update of pre-FEC BER, OSNR, ESNR. 400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos release 4.25.2F.) ...
eos 4.33.2F User Manual - Multi-Chassis Link Aggregation
... in the default state which is the discarding state. This is an expected behavior.     Note: It is highly recommended that both MLAG peer switches are identical platforms and run identical eos images. ...
eos 4.33.2F User Manual - Smart System Upgrade
... upgrade method if you have VRRP configured on the switch. Upgrading the eos image with Smart System Upgrade Using SSU to upgrade the active eos image requires a five-step process: Preparing the ...