Total 11 results found for the keyword of "eos ip address locking"
IP address locking
eos provides IP address locking capabilities when configured on an Ethernet Layer 2
port.
After enabling IP address locking on a Layer 2 (L2) port, the port only permits IP and
ARP ...
... OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos supports multiple OSPFv2 instance configurations on the default VRF and provides isolation as well as segregation ...
...
Configuring Priority-Flow-Control (PFC)
Configuring PFC Watchdog
DCBX and Flow Control Commands
Introduction
eos implements Link Layer Discovery
Protocol (LLDP) and the Data Center Bridging ...
Layer 2 Protocol Forwarding
eos supports Layer2 (L2) Protocol Forwarding on Ethernet interfaces in addition to
Type-5 PW. Also, eos allows selective forwarding of certain L2 Protocol packets, such ...
... to filter routes.
The RACL divergence optimizes hardware resource usage on each forwarding ASIC. eos installs ACLs only on the hardware components corresponding to the member interfaces of the SVIs with ...
... in the default state which is the discarding state. This is an expected behavior.
Note: It is highly recommended that both MLAG peer switches are identical platforms and run identical eos images. ...
Layer 2 Configuration
This chapter contains the following sections:
Spanning Tree Protocol
Link Layer Discovery Protocol
Virtual LANs (VLANs)
DCBX and Flow Control
IP address locking
Layer 2 ...
Spanning Tree Protocol
Spanning Tree Protocols prevent
bridging loops in Layer 2 Ethernet networks. Arista switches support
Rapid Spanning Tree, Multiple Spanning Tree, and Rapid-Per VLAN Spanning
Tree ...
... the successor to Secure Sockets Layer (SSL), is a security protocol used to communicate between client and server. It establishes an encrypted communication channel to secure data.
By default, eos uses ...
... eXtended Packet Numbering (XPN) cipher suites.
MACsec Limitations
The following are the limitations of MACsec:
eos supports MACsec only on point-to-point links unless static SAK is ...
... MLAG.)
QoS
Note: SSU and VRRP are not compatible. Use a different upgrade method if you have VRRP
configured on the switch.
Upgrading the eos image with Smart System
Upgrade
Using SSU to ...