Total 11 results found for the keyword of "eos section 3 6 managing switch configuration settings"
...
Note: In eos releases prior to 4.23.2, this command identified system peers
with IPv6 addresses by their reference IDs (the first four octets of the MD5 hash of
the IPv6 address). In later releases, ...
... secure provisioning, you must ensure that only approved DHCP servers can
communicate with the switch until after completing the ZTP process. Arista also
recommends validating the eos image on your ZTP ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
... distributes operational state information across a set of eos switches to support applications that provide network services. See the CloudVision User Guide, https://www.arista.com/en/support/product-documentation, ...
... often use prefix lists to filter routes.
The RACL divergence optimizes hardware resource usage on each forwarding ASIC. eos installs ACLs only on the hardware components corresponding to the member interfaces ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... in the default state which is the discarding state. This is an expected behavior.
Note: It is highly recommended that both MLAG peer switches are identical platforms and run identical eos images. ...
... control access to eos commands. Three data services conduct authentication, authorization, and accounting (AAA) activities: a local security database, TACACS+ servers, and RADIUS servers.
The Configuring ...
...
This command displays the switch
time.switch(config)# show clock
Mon Jan 14 16:32:46 2013
timezone is America/Los_Angeles
Network Time Protocol (NTP)
eos enables Network Time Protocol (NTP) ...
... CLI.
This chapter includes these sections:
Accessing the eos CLI
Processing Commands
Kernel-based Virtual Machine Commands and configuration
switch Platforms
Command Modes
managing switch
configuration ...