Total 9 results found for the keyword of "eos section 9 1 environment control introduction"
Switch environment control
The following sections describe the commands that display temperature, fan, and power supply
status:
environment control introduction
environment control Overview
Configuring ...
environment control Overview
This section contains the following topics:
Temperature
Fans
Power
Temperature
Arista switches include internal temperature sensors. The number and location ...
... clusters. This means the directly connected
TaskTracker nodes can belong to different clusters. eos supports a maximum of five
clusters per switch.
MapReduce Tracer Configuration
The MapReduce Tracer ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
Latency Analyzer (LANZ)
Arista Networks’ Latency Analyzer (LANZ) is a family of eos features that provide enhanced
visibility into network dynamics, particularly in areas related to the delay packets
experience ...
... STP state. When an interface used as an Ethernet segment does not have a forwarding
state, eos considers the interface to be inactive. For a VLAN-based service, the port must be in a forwarding state
on ...
... area
and interface levels.
Note: On the same area or interface, eos allows security configuration with either AH or ESP but not
both. We can have one area or interface configured with AH and
another ...
... OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos Release 4.22.1F adds support for multiple OSPFv2 instances to
be configured in the default VRF. OSPFv2 Multiple Instances ...
... often use prefix lists to filter routes.
The RACL divergence optimizes hardware resource usage on each forwarding ASIC. eos installs ACLs only on the hardware components corresponding to the member interfaces ...