Total 50 results found for the keyword of "eos show l1 destination"
... can be enabled or disabled on the
fly without impacting regular packet forwarding functionality.
NDR Switch Sensor Extension
NDR switch sensor extends eos telemetry for network threat detection. The ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... template interval 3400000
Hardware Flow Tracking with IPFIX Export
Hardware Flow Tracking uses match criteria to collect data from packets based on defined
flow profiles. eos sends the collected ...
Latency Analyzer (LANZ)
Arista Networks’ Latency Analyzer (LANZ) is a family of eos features that provide enhanced
visibility into network dynamics, particularly in areas related to the delay packets
experience ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
...
Examples
In this example, eos sends hello messages to all known neighbors every
10 seconds. If the switch does not receive
hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses
communication ...
LDP Entropy Label
If a network device uses deep packet inspection for load balancing, Arista
Networks recommends to use entropy label in LDP to improve load balancing in MPLS networks by
providing sufficient ...
RSVP-TE LER
RSVP-TE, the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE),
distributes MPLS labels for steering traffic and reserving bandwidth. The Label Edge
Router (LER) feature ...
RSVP-TE LSR
RSVP-TE applies the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE) to distribute MPLS labels for steering traffic and reserving bandwidth.
The eos implementation supports ...
Sample Configurations
EVPN VXLAN IRB Sample Configuration
In the following topology, we are connecting a Layer 2 site with a Layer 3 site using Layer
3 EVPN (type-5 route). The right side leaves ...
Inter-VRF Local Route Leaking
Inter-VRF local route leaking allows the leaking of routes from one VRF (the source VRF) to
another VRF (the destination VRF) on the same router.
Inter-VRF routes can ...
... mechanisms in eos and the broader use-cases they support are documented here:
Inter-VRF Local Route Leaking using BGP VPN
Inter-VRF Local Route Leaking using VRF-leak Agent
Configuration
The ...
VCS to EVPN Hitless Migration
VCS to EVPN Hitless Migration enables support for migrating from only using VCS as
the control plane to only using EVPN as a control plane in a hitless manner concerning ...
Sharing Equivalence Class entry across multiple VRF
This enables the sharing of the same Forwarding Equivalence Class (FEC) entry across multiple
VRF’s and achieves higher scale in VPN deployments ...
EVPN and VCS Commands
Global Configuration Mode
router
general
Router BGP Configuration Mode
next-hop
resolution disabled
redistribute
service vxlan
route-target
route-target
export
route-target ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
... require the customer routes have them.
eos achieves the above through the extensions to BGP as defined in RFC 4364 for IPv4
and RFC 4659 for IPv6, and the use of VPN Routing and Forwarding Tables (VRFs),
Route ...
EVPN VXLAN Single-Gateway Centralized Routing
In a traditional EVPN VXLAN centralized anycast gateway deployment, multiple L3 VTEPs
serve the role of the centralized anycast gateway. For the hosts ...
... router-mac ba:ed:43:3f:ca:8e
MLAG
This feature applies only to the scenario when two different MLAG VTEP pairs learn the
remote prefix.
Prior to 4.26.0F, eos supports this feature on the primary ...