Total 27 results found for the keyword of "eos 20 4 route maps"
... and destination addresses.. ACLs can also be made dynamic (not persisting in the eos), and the payload keyword can be used to turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
Inter-VRF Local route Leaking Inter-VRF local route leaking allows the leaking of routes from one VRF (the source VRF) to another VRF (the destination VRF) on the same router. Inter-VRF routes can ...
...  show traffic-engineering database Use the show traffic-engineering database to display the topology used for CSPF computations. Starting from eos Release 4.23.1F, the SRLG group details of a neighbor ...
...  Drop count Device ID Egress interface FCS type Reserved TAP Aggregation Extra MPLS Pop (4 to 6 Labels) Available starting with eos Release 4.23.1F extra MPLS pop for TAP Aggregation ...
EVPN and VCS Commands Global Configuration Mode router general router BGP Configuration Mode next-hop resolution disabled redistribute service vxlan route-target route-target export route-target ...
...  Starting in Release eos 4.23.1, ingress on inner IP header matching in MPLS packets is also supported on PBR ACLs. In order to enable this, the following must be configured in a user-defined TCAM profile: ...
BGP/MPLS L3 VPN Border Gateway Protocol/ Multiprotocol Label Switching (BGP/MPLS) L3 Virtual rivate Network (VPN) allows a Service Provider (SP) or an Enterprise to provide the service of interconnecting ...
... identifier or a single Customer Edge (CE) to the participating multiple Provider Edge (PE). The default mode of operation is All-active. Introduced in the eos 4.26.0F for VXLAN, singe-active is another ...
Protocol Independent Multicast Protocol Independent Multicast (PIM) distributes multicast data using routes gathered by other protocols. Arista switches support two types of PIM: PIM Sparse Mode ...
...  Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667. The following enhancements are available by release: eos Release 4.22.1F adds support ...
... hop resolution semantics of BGP routes with an ordered list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified ...
...  Maintenance Mode Configuration Maintenance Mode Commands Overview Using maintenance mode, you can perform several maintenance activities such as: eos image upgrade. Initial configuration or ...
VRRP and VARP A virtual IP (VIP) address is an IP address that does not directly connect to a specific interface. Inbound packets sent to a Virtual IP address are redirected to a physical network ...
...  Configuring Priority-Flow-Control (PFC) Configuring PFC Watchdog DCBX and Flow Control Commands Introduction eos implements Link Layer Discovery Protocol (LLDP) and the Data Center Bridging ...
Layer 3 Configuration This chapter covers the following Layer 3 sections: IPv4 IPv6 Ingress and Egress Per-Port for IPv4 and IPv6 Counters ACLs and route maps VRRP and VARP DirectFlow Decap ...
... ensure disable-vrf configuration to take effect. switch(config)# agent SandL3Unicast terminate SandL3Unicast was terminated Starting from the eos Release 4.26.0F, /32 prefix length optimization ...
... snooping is a Layer 2 feature that is configured on LAN switches. The Arista eos switch supports Option-37 insertion that allows relay agents to provide remote-id information in DHCP request packets. DHCP servers ...
Ingress and Egress Per-Port for IPv4 and IPv6 Counters This feature provides support for per-interface ingress and egress packet and byte counters for both IPv4 and IPv6. This section describes Ingress ...
... MLAG peer switches are identical platforms and run identical eos images. Running different images/platform may result in a failure to form an association with the MLAG peer or see discrepancy in behavior. ...
...  Type Ports ---- ----------- ---- ----- Total Mac Addresses for this criterion: 0 Beginning with eos Release 4.26.0F, PortSec-Protect enforces a limit on the number of MAC addresses, ...