Total 10 results found for the keyword of "eos 25 4 ipv6 command descriptions"
Ingress and Egress Per-Port for IPv4 and ipv6 Counters
This feature provides support for per-interface ingress and egress packet and byte counters for both IPv4 and ipv6.
This section describes Ingress ...
... CLI.
This chapter includes these sections:
Accessing the eos CLI
Processing commands
Kernel-based Virtual Machine commands and Configuration
Switch Platforms
command Modes
Managing Switch
Configuration ...
... displays
information about the active flows maintained in the eos.
command Mode
EXEC
command Syntax
show flow tracking sampled flow-table [
detail | dst-ip |
dst-port | group |
interface | protocol ...
... available for other eos applications.
With hardware acceleration, all sFlow processing is done in hardware
using specialized chips, called accelerators. These accelerators
process sampled packets and ...
... can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This chapter ...
... it is binding a label. Note: All connected interfaces are advertised
as bound. However, eos currently advertised labels for /32 addresses, and FEC filter
is configured to install only x.x.x.200/32
prefixes. ...
...
Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667.
The following enhancements are available by release:
eos Release 4.22.1F adds support ...
VRRP and VARP
A virtual IP (VIP) address
is an IP address that does not directly connect to a specific interface.
Inbound packets sent to a Virtual IP address are redirected to a physical
network ...
...
eos is optimized to support QoS configuration on the Fabric interfaces on 7250x and 7300 series switches. Configuring QoS on the Fabric interfaces in addition to front panel ports allows user to have ...
... 32-bit
integer used in the candidate path selection
algorithm to select the “active” candidate path.
The default value for preference is
100.
Binding SID (BSID): an optional,
SID.Note: In eos, a BSID ...