Total 31 results found for the keyword of "eos 3 5 command modes"
... command replaces the EOS CLI prompt with an SQLite
prompt.switch# event-monitor interact
sqlite>
This command exits SQLite and returns to the EOS CLI
prompt.sqlite> .quit
switch#
event-monitor ...
... CLI.
This chapter includes these sections:
Accessing the eos CLI
Processing commands
Kernel-based Virtual Machine commands and Configuration
Switch Platforms
command modes
Managing Switch
Configuration ...
... can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This chapter ...
...
Drop count
Device ID
Egress interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP Aggregation ...
Latency Analyzer (LANZ)
Arista Networks’ Latency
Analyzer (LANZ) is a family of eos features that provide enhanced visibility
into network dynamics, particularly in areas related to the delay packets
experience ...
... mechanisms in eos and the broader use-cases they support are documented here:
Local Route
leaking using BGP VPN
Local Route
leaking using eos RouteLeak Agent
Configuration
The configuration to ...
Configuring EVPN
Configuring BGP-EVPN and VCS on CVX
Configuring BGP-EVPN
Configuring VNI Bundle
A VNI-aware-bundle represents a MAC-VRF that contains Layer 2 route entries from all VXLAN
Network ...
...
Starting in Release eos 4.23.1, ingress on inner IP header matching
in MPLS packets is also supported on PBR ACLs. In order to enable this, the following must
be configured in a user-defined TCAM profile: ...
BGP/MPLS L3 VPN
Border Gateway Protocol/ Multiprotocol Label Switching (BGP/MPLS) L3 Virtual rivate Network (VPN)
allows a Service Provider (SP) or an Enterprise to provide the
service of interconnecting ...
... identifier or
a single Customer Edge (CE) to the participating multiple Provider Edge
(PE). The default mode of operation is All-active. Introduced in the
eos 4.26.0F for VXLAN, singe-active is
another ...
... offers an echo function. eos supports
asynchronous mode and the echo function.
Asynchronous Mode
Demand Mode
Asynchronous Mode
In asynchronous mode, BFD control packets are exchanged by neighboring ...
Protocol Independent
Multicast
Protocol Independent Multicast
(PIM) distributes multicast data using routes gathered by other protocols.
Arista switches support two types of PIM: PIM Sparse Mode ...
...
Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667.
The following enhancements are available by release:
eos Release 4.22.1F adds support ...
... hop resolution semantics of BGP routes with an ordered list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified ...
... and destination
addresses..
ACLs can also be made dynamic (not persisting in the eos), and the
payload keyword can be used to
turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
... distributes operational state information across a set of eos switches to support applications that provide network services. See the CloudVision User Guide, https://www.arista.com/en/support/product-documentation, ...
... Locking commands
IP Locking
IP Locking is an eos feature configured on an Ethernet Layer 2 port.
When enabled, IP Locking ensures that a port will only permit IP and ARP packets with IP
source ...
... ensure disable-vrf configuration to take effect.
switch(config)# agent SandL3Unicast terminate
SandL3Unicast was terminated
Starting from the eos Release 4.26.0F, /32 prefix length optimization ...
... snooping is a Layer 2 feature that is
configured on LAN switches. The Arista eos switch supports Option-37 insertion that
allows relay agents to provide remote-id information in DHCP request packets. DHCP
servers ...
... (eos release
4.25.2F)
Support of 400GBASE-ZR with Open Forward Error Correction (O-FEC) (eos release
4.25.2F)
Override a transceiver slot’s maximum power limit (eos release
4.25.2F)
Platform Compatibility ...