Total 35 results found for the keyword of "eos evpn"
BGP/MPLS L3 VPN
Border Gateway Protocol/ Multiprotocol Label Switching (BGP/MPLS) L3 Virtual rivate Network (VPN)
allows a Service Provider (SP) or an Enterprise to provide the
service of interconnecting ...
... identifier or
a single Customer Edge (CE) to the participating multiple Provider Edge
(PE). The default mode of operation is All-active. Introduced in the
eos 4.26.0F for VXLAN, singe-active is
another ...
VXLAN Commands
VXLAN Global Configuration
Commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface Configuration
Commands
vxlan flood vtep
vxlan multicast-group ...
Integrated Routing and Bridging
In traditional data center design, inter-subnet forwarding is provided by a centralized
router, where traffic traverses across the network to a centralized routing ...
... it is binding a label. Note: All connected interfaces are advertised
as bound. However, eos currently advertised labels for /32 addresses, and FEC filter
is configured to install only x.x.x.200/32
prefixes. ...
VXLAN DSCP Mapping
VXLAN DSCP Mapping allows selecting Differentiated Services Code Point
DSCPand Traffic Class TC values for packets
at VTEPs ( VXLAN Tunnel Endpoint) along VXLAN encapsulation and ...
... is the protocol used to manage
the membership of hosts in multicast groups for IPv6.
RFC 3810 talks about MLDv2 functionality. MLDv2 is the IPv6 counterpart of IGMPv3. Beginning with eos Release 4.25.0F, ...
IGMP and IGMP Snooping
IGMP Snooping
IGMP Host Proxy
Description
Supported Features
IGMP Protocols
Configuring IGMP
Configuring IGMP Snooping
IGMP Host Proxy
IGMP and IGMP Snooping
Commands ...
VXLAN Description
These sections describe VXLAN architecture, the data objects that comprise a VXLAN network, and
process of bridging packets through a VXLAN network.
VXLAN Architecture
VXLAN Gateway ...
...
Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667.
The following enhancements are available by release:
eos Release 4.22.1F adds support ...
... hop resolution semantics of BGP routes with an ordered list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified ...
... ensure disable-vrf configuration to take effect.
switch(config)# agent SandL3Unicast terminate
SandL3Unicast was terminated
Starting from the eos Release 4.26.0F, /32 prefix length optimization ...
... (eos release
4.25.2F)
Support of 400GBASE-ZR with Open Forward Error Correction (O-FEC) (eos release
4.25.2F)
Override a transceiver slot’s maximum power limit (eos release
4.25.2F)
Platform Compatibility ...
... MLAG peer switches are identical platforms and run identical eos images. Running different images/platform may result in a failure to form an association with the MLAG peer or see discrepancy in behavior. ...
...
MACsec Licensing
MACsec encryption is a eos licensed feature. A valid MACsec license must be configured on a switch. MACsec licenses are tied to a switch serial number and the licensee. ...