Total 10 results found for the keyword of "eos section 10 3 maintenance mode features"
...  maintenance mode Configuration maintenance mode Commands Overview Using maintenance mode, you can perform several maintenance activities, such as: eos image upgrade. Initial configuration ...
... this example, eos sends hello messages to all known neighbors every 10 seconds. If the switch does not receive hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses communication and the ...
... list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified RIB domains, overriding the default behavior. Further, ...
... OSPFv2 adjacencies with DR Other neighbors. OSPFv2 Multiple Instances Support eos supports multiple OSPFv2 instance configurations on the default VRF and provides isolation as well as segregation ...
... area and interface levels. Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another ...
... in section 2.1.1.2 of RFC8667. The following enhancements are available by release: eos Release 4.22.1F adds support for TI-LFA backup paths that protect IS-IS SR labeled traffic corresponding to a ...
... command for shutting down the Tx output path for unidirectional mode. 1-second update of pre-FEC BER, OSNR, ESNR. 400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos release 4.25.2F.) ...
... in the default state which is the discarding state. This is an expected behavior.     Note: It is highly recommended that both MLAG peer switches are identical platforms and run identical eos images. ...
... SR Policy IdentificationThe following identifies an SR policy. Endpoint - An IPv4 or IPv6 address which refers to the destination of the policy. eos allows 0/0 and 0:: and calls these IP addresses null ...
... MLAG.) QoS Note: SSU and VRRP are not compatible. Use a different upgrade method if you have VRRP configured on the switch. Upgrading the eos image with Smart System Upgrade Using SSU to ...