Total 7 results found for the keyword of "eos section 13 2 mlag conceptual overview"
... OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos supports multiple OSPFv2 instance configurations on the default VRF and provides isolation as well as segregation ...
... area
and interface levels.
Note: On the same area or interface, eos allows security configuration with either AH or ESP but not
both. We can have one area or interface configured with AH and
another ...
VRRP and VARP
A virtual IP (VIP) address
is an IP address that does not directly connect to a specific interface.
Inbound packets sent to a Virtual IP address are redirected to a physical
network ...
... The maximum number of ports per LAG varies by platform; numbers for each
platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... in the default state which is the discarding state. This is an expected behavior.
Note: It is highly recommended that both mlag peer switches are identical platforms and run identical eos images. ...
... Configuration
Procedures
VLAN Configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... SR
Policy IdentificationThe following identifies an SR
policy.
Endpoint - An IPv4 or IPv6 address which
refers to the destination of the policy. eos
allows 0/0 and 0:: and calls these IP addresses
null ...