Total 20 results found for the keyword of "eos section 13 6 mlag commands"
Sample Configurations EVPN VXLAN IRB Sample Configuration In the topology below, we are connecting a Layer 2 site with a Layer 3 site using Layer 3 EVPN (type-5 route). Right side leaves are mlag ...
... is used for broadcast, multicast, and unknown unicast traffic. For a list of VXLAN feature support in a specific eos release, consult the appropriate release notes here:https://www.arista.com/en/support/software-download. ...
... is used for broadcast, multicast, and unknown unicast traffic. For a list of VXLAN feature support in a specific eos release, consult the appropriate release notes here:https://www.arista.com/en/support/software-download. ...
... is used for broadcast, multicast, and unknown unicast traffic. For a list of VXLAN feature support in a specific eos release, consult the appropriate release notes here:https://www.arista.com/en/support/software-download. ...
... is used for broadcast, multicast, and unknown unicast traffic. For a list of VXLAN feature support in a specific eos release, consult the appropriate release notes here:https://www.arista.com/en/support/software-download. ...
... is used for broadcast, multicast, and unknown unicast traffic. For a list of VXLAN feature support in a specific eos release, consult the appropriate release notes here:https://www.arista.com/en/support/software-download. ...
...  Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another with ESP. OSPFv3 Authentication ...
IGMP and IGMP Snooping IGMP Snooping IGMP Host Proxy Description Supported Features IGMP Protocols Configuring IGMP Configuring IGMP Snooping IGMP Host Proxy IGMP and IGMP Snooping commands ...
Protocol Independent Multicast Protocol Independent Multicast (PIM) distributes multicast data using routes gathered by other protocols. Arista switches support two types of PIM: PIM Sparse Mode (PIM-SM) ...
VARP Virtual-ARP (VARP) allows multiple switches to simultaneously route packets from a common IP address in an active-active router configuration. Each switch is configured with the same set of virtual ...
OSPFv2 Open Shortest Path First (OSPF) is a link-state routing protocol that operates within a single autonomous system. OSPF version 2 is defined by RFC 2328. This section contains the following ...
... allows for configuring IPv4, IPv6, and MAC access lists and then updating a monitor session with corresponding configuration changes. eos mirrors the packets that match permit statements. eos does not ...
Spanning Tree Protocol Spanning Tree Protocols prevent bridging loops in Layer 2 Ethernet networks. Arista switches support Rapid Spanning Tree, Multiple Spanning Tree, and Rapid-Per VLAN Spanning Tree ...
... Configuration Procedures VLAN Configuration commands VLAN Introduction Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... Across VRF The eos DHCP relay agent supports forwarding of DHCP requests to DHCP servers located in a different VRF to the DHCP client interface VRF. In order to enable VRF support for the DHCP relay ...
... mode as shown below. (config)# management ssh (config-mgmt-ssh)# ip access-group [vrf ] in (config-mgmt-ssh)# ipv6 access-group [vrf ] in In eos 4.19.0, all VRFs are required to use the same ...
...  MACsec encryption is a eos licensed feature. A valid MACsec license must be configured on a switch. MACsec licenses are tied to a switch serial number and the licensee. Every switch running MACsec ...
... are assigned to Ethernet interfaces. Note: PDP is available only in eos versions 4.19.0F and above. A policy map consists of classes. Each class contains an eponymous class map and traffic resolution ...
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... behavior. Note: It is highly recommended that both mlag peer switches are identical platforms and run identical eos images. Running different images/platform may result in a failure to form an association ...