Total 11 results found for the keyword of "eos section 16 3 tap aggregation configuration"
...
Drop count
Device ID
Egress interface
FCS type
Reserved
tap aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for tap aggregation ...
... in the
eos 4.26.0F for VXLAN, singe-active is
another mode of operation in which only one PE per VLAN accepts traffic for
that ethernet segment.
Single-active multihoming is useful for:
Manually controlled ...
... Considerations
The following information should be considered when using the L1 source suite of commands:
eos only enforces speed mismatch on Ethernet to Ethernet, switch to switch, and Ethernet ...
... available for other eos applications.
With hardware acceleration, all sFlow processing is done in hardware
using specialized chips, called accelerators. These accelerators
process sampled packets and ...
... ensure disable-vrf configuration to take effect.
switch(config)# agent SandL3Unicast terminate
SandL3Unicast was terminated
Starting from the eos Release 4.26.0F, /32 prefix length optimization ...
... and destination
addresses..
ACLs can also be made dynamic (not persisting in the eos), and the
payload keyword can be used to
turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
... that are configured by a custom agent using the eos SDK or eAPI
and age out (expire) after a specified time period.
For example, if you are using a custom agent that reacts to traffic sent to the CPU ...
... Type Ports
---- ----------- ---- -----
Total Mac Addresses for this criterion: 0
Beginning with eos Release 4.26.0F,
PortSec-Protect enforces a limit on the number of MAC
addresses, ...
... configuration
Procedures
VLAN configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... command for shutting down Tx output path for unidirectional mode
1-sec update of pre-FEC BER, OSNR, ESNR
Support of 4x100G mode for the 400GBASE-ZR transceivers (eos release 4.25.2F)
Support of 400GBASE-ZR ...
... Considerations
The following information should be considered when using the L1 source suite of commands:
eos only enforces speed mismatch on Ethernet to Ethernet, switch to switch, and Ethernet ...