Total 50 results found for the keyword of "eos section 19 4 configuring ports"
configuring RSVP-TE
The configuration of RSVP-TE requires the configuration of one or more of the following:
configuring RSVP-TE LER
configuring RSVP-TELSR
configuring RSVP-TE P2MP LER ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
...
The following running-config file lists the environment
overheat action command.
switch# show running-config
! Command: show running-config
! device: switch (DCS-7150S-64-CL, eos-4.13.2F)
ip route ...
... Considerations
The following information should be considered when using the L1 source suite of commands:
eos only enforces speed mismatch on Ethernet ...
... Ratio, Residual Inter Symbol Interference, PAM4 Level
Transition Parameters, and other parameters supported on optics interfaces.
Using the Performance Monitoring feature allows eos to collect and maintain ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer Configuration Procedures
VM Tracer ...
... clusters. This means the directly connected
TaskTracker nodes can belong to different clusters. eos supports a maximum of five
clusters per switch.
MapReduce Tracer Configuration
The MapReduce Tracer ...
... template interval 3400000
Hardware Flow Tracking with IPFIX Export
Hardware Flow Tracking uses match criteria to collect data from packets based on defined
flow profiles. eos sends the collected ...
Latency Analyzer (LANZ)
Arista Networks’ Latency Analyzer (LANZ) is a family of eos features that provide enhanced
visibility into network dynamics, particularly in areas related to the delay packets
experience ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
... this example, eos sends hello messages to all known neighbors every
10 seconds. If the switch does not receive
hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses
communication and the ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
LDP Pseudowire
LDP pseudowire provides support for emulating Ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
... eos Release 4.22.0F, the EVPN VXLAN L3 Gateway using EVPN IRB
supports routing traffic from one IPv6 host to another IPv6 host on a stretched VXLAN
VLAN.
IP VPNs Sample Configuration
Here, we examine ...
EVPN Multicast VRF Leaking
Overview
EVPN Multicast virtual routing and forwarding (VRF) Leaking forwards multicast
traffic from a sender in a tenant or external domain (VRF) to a different domain
(VRF) ...
...
VXLAN Decapsulation for interface with multiple VRFs
Please refer to the following security advisory after the eos software upgrade for a
network that leverages VXLAN decapsulation on an interface ...
... the advertising router ID, along with the extended
communities of tunnel type (MPLS), MPLS Label value and
route-target.
Note: You require Release eos 4.21.1F and later versions with Jericho/Jericho+
platforms. ...
... router-mac ba:ed:43:3f:ca:8e
MLAG
This feature applies only to the scenario when two different MLAG VTEP pairs learn the
remote prefix.
Prior to 4.26.0F, eos supports this feature on the primary ...