Total 32 results found for the keyword of "eos section 2 1 initial switch access"
... full10G Not Present
Et4/7 connected1 full10G Not Present
Et4/8 connected1 full10G Not Present
Et4/9 connected1 full10G Not Present
switch>
Referencing Multi-lane Ports
eos supports two types of ...
... behavior.
Note: It is highly recommended that both MLAG peer switches are identical platforms and run
identical eos images. Running different images/platform may result in a failure to form an
association ...
... tasks (including copying the eos image) before
rebooting the control plane
forwarding packets in hardware (based on the last known state) while the
control-plane is offline
optimizing the boot process ...
... the eos image with Smart System
Upgrade
Using SSU to upgrade the active
eos image is a five-step process:
Prepare switch for upgrade ( Prepare the switch for SSU).
Transfer image file to the switch ...
Standard Upgrades and Downgrades
Standard software upgrades
and downgrades on Arista switches are accomplished by installing a different
eos image and reloading the switch. On switches with redundant ...
...
Authentication, Authorization,
and Accounting Overview
This section contains the following topics:
Methods
Configuration Statements
Encryption
Methods
The switch controls access to eos ...
... Sockets Layer (SSL), is a security protocol used
to communicate between client and server. It establishes an encrypted
communication channel to secure data.
By default, eos uses a self signed certificate ...
Connection Management
The switch supports three connection
methods:
console
SSH
Telnet
The switch always enables console and SSH.
Telnet is disabled by default.
Management
commands place the ...
...
Restoring the Factory Default eos Image and Startup Configuration
Restoring the Configuration and Image from a USB Flash Drive
The first three procedures require Aboot Shell
access through the console ...
... server. Command authorization can be provided by eos local configuration
or TACACS+. The XMPP server should use the same authentication source
as the switches. RADIUS is not supported as an XMPP authorization ...
... have not been saved since
the last boot.
boot-config
The boot-config file is an ASCII file that Aboot uses to configure console
communication settings, locate the eos flash image, and specify
initial ...
... system
Aboot 1.9.0-52504.eos2.0
Press Control-C now to enter Aboot shell
To continue the reload process, do nothing. Typing Ctrl-C opens the
Aboot shell; see Aboot Commands for
Aboot editing ...