Total 50 results found for the keyword of "eos section 2 3 configure session"
...
The switch controls access to eos commands by authenticating user identity and verifying user authorization. Authentication, Authorization, and Accounting (AAA) activities are conducted through three ...
... successor to Secure Sockets Layer (SSL), is a security protocol used to communicate between client and server. It establishes an encrypted communication channel to secure data.
By default, eos uses a ...
...
MACsec Licensing
MACsec encryption is a eos licensed feature. A valid MACsec license must be configured on a switch. MACsec licenses are tied to a switch serial number and the licensee. ...
... command replaces the EOS CLI prompt with an SQLite
prompt.switch# event-monitor interact
sqlite>
This command exits SQLite and returns to the EOS CLI
prompt.sqlite> .quit
switch#
event-monitor ...
Initial Configuration and Recovery
This chapter describes initial
configuration and recovery tasks. Subsequent chapters provide details
about features introduced in this chapter.
This chapter contains ...
Connection Management
The switch supports three connection methods:
console
SSH
Telnet
The switch always enables console and SSH.
Telnet is disabled by default.
Management
commands place the ...
... label, and be mounted to the same mount
point with the same options. This makes it possible to boot the eos again by installing
a new boot-config and eos SWI, then rebooting (which can be done using
Aboot/fullrecover). ...
...
Restoring the Factory Default eos Image and Startup Configuration
USB Support for ZeroTouch Provisioning
Restoring the Configuration and Image from a USB Flash Drive
The first three procedures require ...
... CLI.
This chapter includes these sections:
Accessing the eos CLI
Processing Commands
Kernel-based Virtual Machine Commands and Configuration
Switch Platforms
Command Modes
Managing Switch
Configuration ...
... system
Aboot 1.9.0-52504.eos2.0
Press Control-C now to enter Aboot shell
To continue the reload process, do nothing. Typing Ctrl-C opens the
Aboot shell; see Aboot Commands
for Aboot editing ...