Total 5 results found for the keyword of "eos section 20 2 tap aggregation description"
...
tap aggregation QoS Handling on tap Ports
Before eos 4.20.5F, QoS behavior was not enforced for tap aggregation ports, meaning that QoS
behavior for packets passing through the device was not ...
sFlow
This chapter describes Arista's implementation of sFlow, including configuration instructions and command descriptions. Topics covered by this chapter include:
sFlow Conceptual Overview
sFlow ...
... allows for configuring IPv4, IPv6, and MAC access lists and then updating a monitor session with corresponding configuration changes. eos mirrors the packets that match permit statements. eos does not ...
... mode as shown below.
(config)# management ssh
(config-mgmt-ssh)# ip access-group [vrf ] in
(config-mgmt-ssh)# ipv6 access-group [vrf ] in
In eos 4.19.0, all VRFs are required to use the same ...
... full10G Not Present
Et4/7 connected1 full10G Not Present
Et4/8 connected1 full10G Not Present
Et4/9 connected1 full10G Not Present
switch>
Referencing Multi-lane Ports
eos supports two types of ...